强激光与粒子束, 2005, 17 (11): 1693, 网络出版: 2006-04-28   

切削用量对铝靶表面质量的影响

Effect of cutting conditions on surface roughness of aluminum target
作者单位
中国工程物理研究院激光聚变研究中心,四川,绵阳,621900
摘要
采用单点金刚石切削技术,完成了对ICF实验用铝靶的切削加工,重点研究了切削用量对加工表面质量的影响.实验结果表明:采用较小的进给速度,较大的主轴转速能够获得较低的表面粗糙度,切削深度对表面质量影响较小.通过Form Talysurf 表面轮廓仪测量,结果表明表面粗糙度小于50 nm.
Abstract
In this paper,the Al target in ICF experiment was produced by single point diamond turning technology.The effect of turning process on the surface roughness of Al target was discussed.The experiment results have demonstrated that lower surface roughness of Al target can be fabricated with smaller feed speed and higher spindle rotate speed.The surface roughness was analyzed by means of Form Talysurf device.The result showed that the surface roughness of the aluminum target was less than 50 nm.

谢军, 黄燕华, 杜凯, 袁光辉, 郑凤成, 黄丽珍, 朱磊. 切削用量对铝靶表面质量的影响[J]. 强激光与粒子束, 2005, 17(11): 1693. XIE Jun, HUANG Yan-hua, DU Kai, YUAN Guang-hui, ZHENG Feng-cheng, HUANG Li-zhen, ZHU Lei. Effect of cutting conditions on surface roughness of aluminum target[J]. High Power Laser and Particle Beams, 2005, 17(11): 1693.

本文已被 1 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!