量子电子学报, 2005, 22 (2): 251, 网络出版: 2006-05-15  

不同退火温度下金属/4H-SiC Schottky势垒高度的研究

Study on Schottky barrier of 4H-SiC at different anealing temperature
作者单位
1 厦门大学物理系,福建,厦门,361005
2 厦门大学萨本栋微机电中心,福建,厦门,361005
摘要
采用磁控溅射的方法在4H-SiC样品上分别沉积四种金属薄膜(Ag,Cu,Ni,Cr)形成Schottky接触,研究了不同温度退火对Schottky势垒高度的影响.通过对样品的I-V测试结果的拟合,得到各金属/4H-SiC Schottky接触的势垒高度以及理想因子.在反向偏压100V下,样品的反向漏电流小于10-10A,说明样品的反向特性良好.样品经过不同温度的退火后,发现Cu、Ni与4H-SiC的势垒高度(SBH)随退火温度的升高而提高,超过某一温度,其整流特性变差;Ag、Cr的SBH在退火后降低.SBH与金属功函数呈线性关系(Cr金属除外),斜率为0.11.
Abstract
Schottky barriers were formed by sputtering the metals on the front side of 4H-SiC(Si face) by magnetron sputtering to study the rectifying characteristics of the contacts between the metals and 4H-SiC. The infections of the annealing under different temperature were also studied. Schottky barrier height (SBH) of metal/4H-SiC was evaluated from I-V measurements. Under a reverse voltage about 100 V, the reverse leaky current is below 0.1 nA. After annealed, the SBH of Cu/, Ni/4H-SiC was increased, but the SBH of Cr/, Ag/4H-SiC contact was decreased. The relationship between the work function of metals and the SBH was presented. The barrier height depends on the metal work function with slopes of 0.1 to 0.2 (except metal Cr).

杨克勤, 陈厦平, 杨伟锋, 孔令民, 蔡加法, 林雪娇, 吴正云. 不同退火温度下金属/4H-SiC Schottky势垒高度的研究[J]. 量子电子学报, 2005, 22(2): 251. 杨克勤, 陈厦平, 杨伟锋, 孔令民, 蔡加法, 林雪娇, 吴正云. Study on Schottky barrier of 4H-SiC at different anealing temperature[J]. Chinese Journal of Quantum Electronics, 2005, 22(2): 251.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!