光子学报, 2006, 35 (10): 1608, 网络出版: 2010-06-03  

压印光刻中的两步对正技术

A Novel Two-Step Alignment Technique for Imprint Lithography
作者单位
西安交通大学机械制造系统工程国家重点实验室,西安 710049
摘要
压印光刻中套刻需要粗、精两级对正.实验采用一对斜纹结构光栅作为对正标记.利用物镜组观察光栅标记图像的边界特征进行粗对正,其准确度在精对正信号的捕捉范围内;利用光电接收器件阵列组合接收光栅莫尔信号,在莫尔信号的线区进行精对正.由于线性区的斜率大,精对正过程中得到相应x,y方向的对正误差信号灵敏度高,利用高灵敏度对正误差信号作为控制系统的驱动信号,对承片台进行驱动定位,实现精对正.最终使X,Y方向上的重复对正准确度分别达到了±21 nm(±3σ)和±24 nm(±3σ).
Abstract
A two-step alignment,coarse-fine alignment,is proposed for obtaining high alignment accuracy in room-temperature imprint lithography process. A pair of special slant gratings are used as alignment marks. Coarse alignment was realized by observing the borderlines of the superposed marks through object lens,and alignment accuracy is within the capture range of fine alignment. The Moiré signals in the linear region for fine alignment generated by the alignment marks were detected by a photo-detector array and used to estimate the fine alignment errors in x and y directions respectively. Since the linear region of moiré signal is very steep,the signals highly sensitive to alignment error can be obtained and used to control the alignment of a X-Y stage by fine positioning. The final alignment accuracy can reach ±21 nm in x direction and±24 nm in y direction.

王莉, 卢秉恒, 丁玉成, 刘红忠. 压印光刻中的两步对正技术[J]. 光子学报, 2006, 35(10): 1608. Wang Li, Lu Bingheng, Ding Yucheng, Liu Hongzhong. A Novel Two-Step Alignment Technique for Imprint Lithography[J]. ACTA PHOTONICA SINICA, 2006, 35(10): 1608.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!