中国激光, 2009, 36 (4): 1011, 网络出版: 2009-04-27   

激光烧结厚膜正温度系数热敏电阻浆料的研究

Study of Laser Sintering of Thick-Film Positive Temperature Coefficient Thermistor Paste
作者单位
华中科技大学光电子科学与工程学院武汉光电国家实验室(筹)激光部,湖北 武汉 430074
摘要
采用激光烧结厚膜电子浆料技术,在三氧化二铝陶瓷基板上制备厚膜正温度系数(PTC)热敏电阻。研究了激光工艺参数以及后续热处理温度对PTC热敏电阻线宽、形貌和性能的影响规律。激光烧结制得的厚膜PTC热敏电阻最小线宽为40 μm,电阻温度系数(TCR)可达2965×10-6/℃,其性能与传统的炉中烧结相当。 激光功率密度和后续热处理温度对PTC热敏电阻方阻和电阻温度系数影响较大,并都存在一个最佳值。
Abstract
Thick-film positive temperature coefficient (PTC) thermistor on Al2O3 ceramic substrate was prepared by laser sintering of thick-film electronic paste. The effects of laser processing parameters and the temperature of post heat processing on thick-film PTC thermistor width, surface microstructure and performance were studied. The minimum linewidth of thick-film PTC thermistor by laser sintering is 40 μm. The temperature coefficients of resistivity (TCR) of PTC thermistor is around 2965×10-6/℃, and the performance is equivalent to traditional oven-fired electrical paste. The laser power density and the temperature of post heat processing have great effect on the sheet resistivity and TCR of PTC thermistor, and there exist optimum values for these parameters.

蔡志祥, 李祥友, 胡乾午, 曾晓雁. 激光烧结厚膜正温度系数热敏电阻浆料的研究[J]. 中国激光, 2009, 36(4): 1011. Cai Zhixiang, Li Xiangyou, Hu Qianwu, Zeng Xiaoyan. Study of Laser Sintering of Thick-Film Positive Temperature Coefficient Thermistor Paste[J]. Chinese Journal of Lasers, 2009, 36(4): 1011.

本文已被 2 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!