激光技术, 2009, 33 (5): 486, 网络出版: 2010-03-11   

光纤激光直接快速成型316L不锈钢精密零件研究

Research on direct rapid manufacturing of 316L fine metal part using fiber laser
作者单位
1 华南理工大学 机械与汽车工程学院,广州 510640
2 广州瑞通千里激光设备有限公司,广州 510380
摘要
为了研究光纤激光在选区激光熔化直接成型316L不锈钢精密零件中的应用,采用扩束镜及f-θ透镜,将光纤激光在成型系统工作面上聚集成30μm~50μm左右的细微聚焦光束;通过分析离焦量、扫描速度、激光功率、扫描路径对比成型实验,获得了激光光斑直径、扫描速度、激光功率等工艺参量及扫描路径对成型精度的影响关系。结果表明,通过优化工艺参量及扫描路径,可成功成型壁厚达0.1mm的316L不锈钢精密零件。
Abstract
In order to study the application of fiber laser in direct manufacturing of 316L stainless steel fine part by selective laser melting(SLM),a fiber laser was focused to a minimal fine spot size of 30μm~50μm on the work plane of the SLM system by means of a beam expander and f-θ lens.After analyzing some SLM experiment results under different conditions of defocus,laser power,scanning speed and path,the effect of the above parameters on the part prototyping accuracy was found.The analysis result shows that a stainless 316L part with minimal thin wall of 0.1mm can be built through optimization of processing parameters and scanning path.

吴伟辉, 杨永强, 王红卫, 王迪. 光纤激光直接快速成型316L不锈钢精密零件研究[J]. 激光技术, 2009, 33(5): 486. WU Wei-hui, YANG Yong-qiang, WANG Hong-wei, WANG Di. Research on direct rapid manufacturing of 316L fine metal part using fiber laser[J]. Laser Technology, 2009, 33(5): 486.

本文已被 6 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!