应用光学, 2010, 31 (1): 124, 网络出版: 2010-05-31  

五角棱镜补偿法加工工艺研究

Error compensation for pentagonal prism
作者单位
西安应用光学研究所, 陕西 西安 710065
摘要
由于五角棱镜两B棱的投影夹角对第二光学平行差影响倍率较大且加工过程中无法测量该夹角,从而导致棱镜加工合格率较低。通过分析侧面垂直度误差及Δ45°对五角棱镜光学平行差的影响,提出一种新的五角棱镜加工工艺方法:利用最后一个加工面对前3个已加工面存在的角度误差进行一次性补偿,从而降低了对各加工面的加工误差要求。实践证明:该方法能够有效地提高五角棱镜加工的合格率和生产效率,减小加工难度,并能显著降低对加工和检测设备的精度要求。
Abstract
The projection angle of two B-edges of pentagonal prism has a great effect on the second optical parallelism; however, it cannot be measured during on line processing, which results in low qualification rate. By analyzing the impact of perpendicular error of the side face and angle error of 45° on the optical parallelism of pentagonal prism, this paper provides a new process for producing pentagonal prism, which modified the angle error of the last face to compensate the angle errors of three processed faces so as to release the strict requirements for process error of these surfaces. By using this process, qualification rate and productivity was raised, the complexity of the process was reduced, and the strict requirements for the machine and measurement equipments were released.

刘昕, 苏瑛, 支西玲, 杨崇民, 刘新武, 樊春丽. 五角棱镜补偿法加工工艺研究[J]. 应用光学, 2010, 31(1): 124. LIU Xin, SU Ying, ZHI Xi-ling, YANG Chong-min, LIU Xin-wu, FAN Chun-li. Error compensation for pentagonal prism[J]. Journal of Applied Optics, 2010, 31(1): 124.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!