激光技术, 2008, 32 (4): 0399, 网络出版: 2010-06-03   

线偏振CO2激光对非金属材料切缝的影响

Effect of linear polarized CO2 lasers on cut kerfs of nonmetallic material
作者单位
广东工业大学 机电工程学院,广州 510006
摘要
为了研究线偏振C02激光对高吸收率非金属材料的影响,采用线偏振C02激光沿着不同的方向切割模切板,研究不同激光功率、切割速度、切割方向、辅助气体对切缝宽度的影响,同时对比线偏振激光切割低碳钢。试验结果表明,改变激光功率和切割速度对模切板进行切割,上、下切缝沿不同方向之间的宽度相差不大,即偏振性对高吸收率非金属材料模切板的切缝影响不大,但是对金属材料影响很大。辅助气体N2和空气对上下切缝的影响不大,从经济角度应优先选择空气;为了得到上下均匀一致的切缝,同一激光功率下,切割速度应小些,而同一切割速度下,激光功率应大些。
Abstract
Highly absorptive nonmetallic material,die-board,was cut by linear polarized CO2 lasers through eight different directions. Effect of laser power,cutting speed and assisted air on the width of the cut kerfs of the die-board was also discussed by contrast with that of lower carbon steel. The results indicate that the difference between the top and the bottom kerfs width of the die-board along eight directions is not sensitive to linear polarization with altering laser power and cutting speed,while the kerf width difference of steel is on the contrary. Assisted gas such as N2 and air has little effects on the kerf,therefore air should be selected in view of lower cost. Uniform cut kerfs can be achieved with lower cutting speed under certain laser power or higher laser power at a certain cutting speed.

谢小柱, 魏昕, 胡伟. 线偏振CO2激光对非金属材料切缝的影响[J]. 激光技术, 2008, 32(4): 0399. XIE Xiao-zhu, WEI Xin, HU Wei. Effect of linear polarized CO2 lasers on cut kerfs of nonmetallic material[J]. Laser Technology, 2008, 32(4): 0399.

本文已被 2 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!