强激光与粒子束, 2012, 24 (2): 285, 网络出版: 2012-05-08   

短脉冲激光对硅基探测器的热作用模型选择

Selection of heat transfer model for describing short-pulse laser heating silica-based sensor
作者单位
解放军电子工程学院 脉冲功率激光技术国家重点实验室, 合肥 230037
摘要
从傅里叶模型和非傅里叶模型的基本方程出发,通过有限差分方法对方程进行数值求解。分别分析了10, 1.0, 0.1, 0.01 ns这4种脉宽的脉冲激光作用于硅材料时两种传热模型温度曲线的相对变化;讨论了热弛豫时间对非傅里叶模型数值结果的影响。结果表明:脉宽小于或等于100 ps的激光作用于硅材料时,表层温度上升缓慢,会发生载流子效应,非傅里叶模型可以合理地反映这种现象;对于一般材料,载流子效应发生的条件是脉宽小于或等于材料热弛豫时间,此时应当用非傅里叶模型描述加热过程。
Abstract
The fundamental equations of Fourier heat transfer model and non-Fourier heat transfer model were numerically solved, with the finite difference method. The relative changes between temperature curves of the two heat transfer models were analyzed under laser irradiation with different pulse widths of 10 ns, 1 ns, 100 ps, 10 ps. The impact of different thermal relaxation time on non-Fourier model results was discussed. For pulses of pulse width less than or equal to 100 ps irradiating silicon material, the surface temperature increases slowly and carrier effect happens, which the non-Fourier model can reflect properly. As for general material, when the pulse width is less than or equal to the thermal relaxation time of material, carrier effect occurs. In this case, the non-Fourier model should be used.

郝向南, 聂劲松, 李化, 卞进田. 短脉冲激光对硅基探测器的热作用模型选择[J]. 强激光与粒子束, 2012, 24(2): 285. Hao Xiangnan, Nie Jinsong, Li Hua, Bian Jintian. Selection of heat transfer model for describing short-pulse laser heating silica-based sensor[J]. High Power Laser and Particle Beams, 2012, 24(2): 285.

本文已被 2 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!