强激光与粒子束, 2013, 25 (5): 1303, 网络出版: 2013-04-08   

多间隙气体开关触发放电过程及击穿抖动

Discharge process and closure jitter of six-stage gas switch under pulsed trigger
作者单位
西北核技术研究所 强脉冲辐射模拟与效应国家重点实验室, 西安 710024
摘要
实验研究了开关闭合抖动随欠压比和脉冲触发电压的变化关系, 利用紫外光纤探测器测量不同间隙放电时延, 分析了放电过程对多间隙开关闭合抖动的影响, 并研究采用预电离方法降低开关触发电压。实验表明: 开关抖动随脉冲触发电压与欠压比的乘积增大呈指数下降趋势; 当触发电压和欠压比的乘积大于33 kV时, 开关抖动小于5 ns; 乘积大于45 kV时, 开关抖动降到3 ns以下并趋于饱和; 对六间隙气体开关抖动的贡献, 触发间隙占30%~40%, 其余5个间隙为60%~70%; 欠压比和触发电压对触发间隙击穿抖动的影响最大, 对随后放电的3个间隙影响较小, 对最后2个间隙几乎无影响; 当欠压比大于57%时, 采用预电离措施使开关的触发电压降低了10 kV以上。
Abstract
Closure jitter versus voltage ratio and trigger voltage was experimentally measured for a six-stage gas switch. An ultra-violet fiber system was used to diagnose the discharge process influencing the closure jitter, and a pre-ionizing measure was employed to decrease the trigger voltage. It is found that the switch closure jitter declines exponentially with the product of trigger voltage and voltage ratio. The trigger gap accounts for 30%-40% of the closure jitter while the other five gaps account for 60%-70%. The trigger voltage and voltage ratio have more influences on the jitter of the trigger gap which breaks down first, than on that of the three gaps discharging subsequently, and hardly affects the last two gaps. For the switch with a voltage ratio greater than 57%, the pre-ionizing measure finally lowers the trigger voltage by over 10 kV.

丛培天, 邱爱慈, 孙铁平, 盛亮, 李阳, 张美. 多间隙气体开关触发放电过程及击穿抖动[J]. 强激光与粒子束, 2013, 25(5): 1303. Cong Peitian, Qiu Aici, Sun Tieping, Sheng Liang, Li Yang, Zhang Mei. Discharge process and closure jitter of six-stage gas switch under pulsed trigger[J]. High Power Laser and Particle Beams, 2013, 25(5): 1303.

本文已被 5 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!