强激光与粒子束, 2014, 26 (6): 063103, 网络出版: 2014-06-03   

345 GHz微折叠波导慢波结构的粗糙度和加工垂直度

Waveguide roughness and exposure steepness for 345 GHz folded waveguide traveling wave tube
张芳 1,2,*董志伟 1,2
作者单位
1 北京应用物理与计算数学研究所, 北京 100094
2 中国工程物理研究院 太赫兹研究中心, 四川 绵阳 621900
摘要
通过理论和数值模拟方法,考虑金属粗糙度的情况下,研究了加工垂直度公差角在0~6°范围内变化时折叠波导慢波结构的工作性能,结果表明:金属波导表面的粗糙度增大时,慢波结构中电磁信号的传输损耗增大;垂直度公差角的增大也使得电磁信号的传输损耗增加,而且垂直度公差角所引起的结构变化会引起器件的电压工作点漂移、带宽降低等。
Abstract
In the MEMS fabrication process of 345 GHz micro-electric vacuum folded waveguide traveling wave tube(FWG-TWT), the surface roughness and the verticality of waveguide’s sidewall are two major challenges. Through theoretical analysis and numerical simulation, the paper considered the roughness and studied the changes of FWG slow wave structure’s performance when the vertical angle tolerance increased from 0° to 6°. When the surface roughness of the waveguide became bigger, the signal’s transmission loss of the slow wave structure increased. When the angle’s tolerance increased, the signal’s transmission loss rose, and angle tolerance which means structure change caused the device’s operating voltage drift, bandwidth reduction, etc. The results in this paper is helpful for the device’s experiment and the processing.

张芳, 董志伟. 345 GHz微折叠波导慢波结构的粗糙度和加工垂直度[J]. 强激光与粒子束, 2014, 26(6): 063103. Zhang Fang, Dong Zhiwei. Waveguide roughness and exposure steepness for 345 GHz folded waveguide traveling wave tube[J]. High Power Laser and Particle Beams, 2014, 26(6): 063103.

本文已被 1 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!