红外, 2014, 35 (9): 31, 网络出版: 2014-10-23  

猫眼逆向调制激光通信接收放大电路的设计

Design of Receiving Amplifier Circuit for Cat’s Eye Modulating Retro-reflecting Laser Communication
作者单位
1 装备学院研究生院, 北京 101416
2 装备学院光电装备系, 北京 101416
摘要
猫眼逆向调制激光通信由于通信速率高, 回波信号微弱, 对接收放大电路提出了低噪声、高增益和宽带宽的严格要求。首先分析了猫眼逆向调制激光通信链路模型和信噪比对误码率的影响。然后, 根据系统设计指标分析了电路的带宽、增益和噪声限度等性能参数;在此基础上设计了由跨阻放大模块和增益可变主放大模块构成的接收放大电路。最后, 计算了电路的总噪声, 并对电路的响应特性进行了仿真。该接收放大电路的带宽达到140 MHz, 信号增益大于70 dB, 总噪声电流约为1.34×10-7 A。结果表明, 该设计能满足系统后续的数据处理要求。
Abstract
Because of high communication speed and weak echo signals, cat’s eye modulating retro-reflecting laser communication has strict requirements of low noise, high gain and wide bandwidth for receiving amplifier circuits. Firstly, the influence of link models for cat’s eye modulating retro-reflecting laser communication and Signal-to-Noise Ratio (SNR) on Bit Error Rate (BER) is analyzed. Then, the parameters such as circuit bandwidth, gain and noise limit are analyzed according to the performance specifications of the system. On this basis, a receiving amplifier circuit consisting of a transimpedance preamplifier module and a main amplifier module with adjustable gain is designed. Finally, its total noise is calculated and its response characteristics are simulated. It has the bandwidth of 140 MHz, the signal gain greater than 70 dB and the total noise current about 1.34×10-7A. The result shows that the design of the circuit can meet the requirement of following data processing of the system.

杨继光, 孙华燕, 樊桂花. 猫眼逆向调制激光通信接收放大电路的设计[J]. 红外, 2014, 35(9): 31. YANG Ji-guang, SUN Hua-yan, FAN Gui-hua. Design of Receiving Amplifier Circuit for Cat’s Eye Modulating Retro-reflecting Laser Communication[J]. INFRARED, 2014, 35(9): 31.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!