红外与激光工程, 2016, 45 (11): 1105004, 网络出版: 2017-01-20  

基于REC技术的激光器阵列光源模块设计

Design of laser array light source module based on REC technology
作者单位
1 江南大学 物联网工程学院, 江苏 无锡 214132
2 南京大学 现代工程与应用科学学院, 江苏 南京 210093
摘要
近年来, 单片集成的多波长激光器阵列作为波分复用(WDM)系统的理想光源而成为研究热点。通过重构-等效啁啾(REC)技术实现了一种低成本的分布反馈式(DFB)激光器阵列光源模块, 采用掺铒光纤放大器(EDFA)对该激光器阵列的输出进行了光学放大, 并通过PID控制程序对光源输出进行稳定化调节。光源模块中各通道激光器的中心波长间隔均匀, 平均间隔为1.64 nm, 波长间隔的误差小于0.2 nm。光源所输出的总光功率大于50 mW, 输出光功率变化小于0.02 dBm。
Abstract
In recent years, monolithic integrated multi wavelength laser array(MLA) has become a hot research topic, as an ideal light source in the wavelength division multiplexing system. A low-cost distributed-feedback(DFB) laser array light source module based on reconstruction-equivalent-chirp(REC) technology was demonstrated. The output of this module was amplified by Erbium-doped fiber amplifier (EDFA) and adjusted by PID control program. The center wavelength spacing of the light source module was uniform. The average interval was 1.64 nm, and the wavelength spacing deviation was less than 0.2 nm. The total output power of the light source was more than 50 mW and the output light power change was less than 0.02 dBm.

倪屹, 刘森, 陆骏, 曾盼. 基于REC技术的激光器阵列光源模块设计[J]. 红外与激光工程, 2016, 45(11): 1105004. Ni Yi, Liu Sen, Lu Jun, Zeng Pan. Design of laser array light source module based on REC technology[J]. Infrared and Laser Engineering, 2016, 45(11): 1105004.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!