强激光与粒子束, 2017, 29 (2): 024101, 网络出版: 2017-02-10  

初始温度及碳源对碳纳米管气相爆轰法合成的影

Influence of initial temperature and carbon source on carbon nanotubes prepared by gaseous detonation
作者单位
1 大连理工大学 工程力学系, 辽宁 大连116024
2 工业装备结构分析国家重点实验室, 辽宁 大连 116024
摘要
改变初始温度以及分别使用甲烷和乙炔气体作碳源时气相爆轰合成碳纳米管,研究了初始温度与不同碳源对碳纳米管的影响。利用X射线衍射(XRD)、透射电镜(TEM)、拉曼(Raman)光谱等对碳纳米管进行表征。结果表明,随着初始温度的升高,所合成的碳纳米管的产量减少且石墨化程度降低,但管壁会变得光滑且管径有所增加。当使用乙炔时,所合成的产物中没有碳纳米管,而是合成了石墨化程度较高的无定形碳,随着催化剂量的增加,产物中碳包覆颗粒增多且包覆层清晰可见,但存在结构缺陷。当初始温度在110~130 ℃时,使用甲烷气体运用气相爆轰的手段是合成碳纳米管的较佳方案。
Abstract
In the paper, the effects of two factors changing initial temperature and using methane and acetylene as different carbon source on synthesis of carbon nanotubes(CNTs) by gaseous detonation were studied. The CNTs were characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM) and Raman spectroscopy. The results show that with the increase of the initial temperature, the yield of the synthesized carbon nanotubes is reduced and the degree of graphite is reduced, but the wall of the tube will be smooth and the diameter of the pipe will be increased. When using the acetylene, there are no carbon nanotubes in the synthesized products but synthesized amorphous carbon with higher graphitization degree. With increase of the amount of catalyst, product carbon coated particles increase and coating layer is clearly visible, but there are some structural defects. When the initial temperature ranges from 110 ℃ to 130 ℃, the use of methane gas is a better solution for the synthesis of CNTs with the gaseous detonation method.

杨瑞, 李晓杰, 闫鸿浩, 王洋. 初始温度及碳源对碳纳米管气相爆轰法合成的影[J]. 强激光与粒子束, 2017, 29(2): 024101. Yang Rui, Li Xiaojie, Yan Honghao, Wang Yang. Influence of initial temperature and carbon source on carbon nanotubes prepared by gaseous detonation[J]. High Power Laser and Particle Beams, 2017, 29(2): 024101.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!