应用激光, 2017, 37 (2): 229, 网络出版: 2017-06-08
激光—电弧复合焊不同引导方式对其焊接成形质量的影响研究
Study on the Influence of Different Laser-MIG Arc Hybrid Welding Methods on the Welding Quality of Aluminum Alloy
铝合金 激光-电弧复合焊接 引导方式 成形质量 aluminum alloy laser-MIG arc hybrid welding methods welding guide way quality of form
摘要
为了研究激光-电弧复合焊不同引导方式对铝合金焊接成形质量的影响, 采用YAG激光-MIG电弧复合热源对10 mm厚5083铝合金板进行平板堆焊试验, 并采用HANNOVER电弧分析仪、高速摄像机、金相显微镜等设备研究不同引导方式下焊缝宏观组织和微观组织的影响。研究表明, 不同引导方式对焊缝成形有较大影响。电弧引导激光焊接(Arc-laser hybrid welding leading, AL)时, 激光与电弧两热源的耦合效果好, 焊缝截面成型良好, 为典型的“蘑菇”状; 激光引导电弧焊接(Laser-Arc hybrid welding leading, LL)激光电弧作用区主要为等轴细晶粒, AL为明显的等轴树枝晶和细小的等轴晶粒。同时二者接头焊缝中心硬度值均略低于焊缝中心到熔合线之间的硬度值。LL焊接较AL时熔池振荡严重, 熔滴易呈爆炸倾向过渡。
Abstract
In order to study different Laser-MIG Arc Hybrid Welding methods on the quality of aluminum alloy welding guide way, the YAG laser-MIG arc composite heat source to 10 mm thick plate welding experiment of 5083 aluminum alloy plate. And uses the HANNOVER arc analyzer, high-speed cameras, metallographic microscope, equipment research weld macrostructure and microstructure under different leading way. Research shows, different ways to lead the formation of a greater impact on the welding. Arc-laser hybrid welding leading, the coupling effect of laser and arc heat source is good. Weld section forming well, for the typical "mushroom" shape. Laser-Arc hybrid welding leading. The laser-arc zone is mainly composed of equiaxed fine grains.AL method is obvious equiaxed dendrites and fine equiaxed grains. While the joint hardness of the two joints are slightly lower than the weld center to the weld line between the hardness value. LL method welding pool than the AL serious oscillation, droplet prone to explosive tendency to transition.
张亚亮, 刘佳, 石岩, 杨玉东. 激光—电弧复合焊不同引导方式对其焊接成形质量的影响研究[J]. 应用激光, 2017, 37(2): 229. Zhang Yaliang, Liu Jia, Shi Yan, Yang Yudong. Study on the Influence of Different Laser-MIG Arc Hybrid Welding Methods on the Welding Quality of Aluminum Alloy[J]. APPLIED LASER, 2017, 37(2): 229.