液晶与显示, 2018, 33 (1): 61, 网络出版: 2018-03-14  

基于FT600的USB3.0接口设计

Design of USB3.0 interface based on FT600
作者单位
1 中国科学院 长春光学精密机械与物理研究所, 吉林 长春 130033
2 中国科学院大学, 北京 100049
摘要
为了简化相机调试系统, 降低调试成本, 设计了基于FTDI公司的FT600芯片的USB3.0接口。首先, 对Camera Link接口相机调试的复杂性和USB3.0接口调试的优势做了简要介绍, 接着, 对整个接口的硬件电路设计过程进行了说明,根据相应的数据手册,完成了对FT600芯片外围电路及控制芯片, 现场可编程门阵列(FPGA)外围电路的设计。最后, 用Verilog硬件描述语言(Verilog HDL)对FPGA内部完成编程, 并通过FTDI公司提供的上位机程序对所设计的接口进行了测试。测试结果表明, 该USB3.0接口电路能够通过上位机软件对工作模式进行设置, 并能以200 MB/s左右的速率对数据进行传输。能够满足相机调试时的需求, 达到简化调试系统的目的。
Abstract
In order to simplify the system for camera testing and reduce the cost, an USB3.0 interface based on FT600 of FTDI Company is designed. First, a brief introduction of the complexity for testing the camera with Camera link interface and the advantage for using USB3.0 interface is presented. Then an explanation for circuit design of the interface is showed, and according to the datasheet, the circuit design of the FT600 and the FPGA is accomplished. Finally, the FPGA is programmed by using the Verilog HDL and the USB3.0 interface is tested by using the software provided by the FTDI. Experimental results indicate that the work mode of the USB3.0 interface can be configured according to software, and the interface can transfer the data at 200 Mbyte/s. It can satisfy the camera test requirements and simplify the system for testing.

陈涛, 赵金宇, 贾建禄. 基于FT600的USB3.0接口设计[J]. 液晶与显示, 2018, 33(1): 61. CHEN Tao, ZHAO Jin-yu, JIA Jian-lu. Design of USB3.0 interface based on FT600[J]. Chinese Journal of Liquid Crystals and Displays, 2018, 33(1): 61.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!