醋酸铯合成CsPbBr<sub>3</sub>全无机钙钛矿量子点及薄膜发光特性

韩丽锦; 马雪; 张源涛; 董鑫; 吴国光; 张宝林

doi:doi:10.37188/cjl.20200143

发光学报, 2020, 41 (11): 1367, 网络出版: 2020-12-25

醋酸铯合成CsPbBr₃全无机钙钛矿量子点及薄膜发光特性

Luminescence Properties of all Inorganic Perovskite CsPbBr₃ Quantum Dots and Film Synthesized by Cesium Acetate

论文大纲

韩丽锦 ^*马雪张源涛董鑫吴国光张宝林

作者单位

吉林大学电子科学与工程学院集成光电子学国家重点联合实验室, 吉林长春 130012

钙钛矿量子点 perovskite CsPbBr3 CsPbBr3 quantum dot XRD XRD PL PL

摘要

为优化反应过程对合成钙钛矿量子点及其薄膜质量的影响,本文采用相较于碳酸铯溶解性更好的醋酸铯为原料合成前驱体,并对不同条件下合成的量子点及制备的薄膜进行一系列特性表征。在不同反应温度及反应时间条件下采用热注入法合成CsPbBr3全无机钙钛矿量子点,在不同旋涂速度及退火时间条件下制备量子点薄膜。对制得的量子点进行X射线衍射、吸收光谱、荧光寿命、透射电子显微镜测试,对量子点薄膜进行光致发光特性表征。发现采用溶解性更好的醋酸铯为原料合成前驱体制备CsPbBr3全无机钙钛矿量子点,在反应温度为180 ℃、反应时间为5 s时,量子点尺寸最小,为8 nm,荧光寿命最长,为8 ns,晶体质量和吸收特性更好; 旋涂速度为3 000 r/min、退火时间为10 min条件下制得的CsPbBr3量子点薄膜光致发光强度最强、半峰宽最小。相较于相同条件下以碳酸铯为原料合成的量子点材料,以醋酸铯为原料合成的量子点溶液及薄膜各项性能均有提升。

Abstract

In order to optimize the influence of reaction process on the quality of synthesized perovskite quantum dots(QDs) and the QDs thin films, cesium acetate is used as the raw material for the synthesis of precursors because of its better solubility than cesium carbonate. A series of properties of quantum dots and films prepared under different conditions were characterized. CsPbBr3 all-inorganic perovskite quantum dots were synthesized by heat-injection with different reaction temperatures and reaction times. The CsPbBr3 quantum dot films were prepared via different spin coating rates and annealing times. X-ray diffraction, absorption spectrum, fluorescence lifetime and TEM tests were carried out on the prepared QDs and the photoluminescence properties of the QD films were characterized. CsPbBr3 all-inorganic perovskite quantum dots were prepared by using cesium acetate with better solubility as the raw material for synthesis. It is found for the reaction temperature of 180 ℃ and the reaction time of 5 s, the quantum dots have smaller size of 8 nm and longer fluorescence life of 8 ns with high crystal quality and absorption characteristics. CsPbBr3 QD films prepared with rotation coating speed of 3 000 r/min and annealing time of 10 min have higher photoluminescence intensity and smaller full width at half maxima. Compared with quantum dot materials synthesized from cesium carbonate at the same conditions, quantum dots synthesized from cesium acetate as raw materials and the QD films have better optical properties.

参考文献

[1] 李今朝,曹焕奇,张超,等. 气相辅助刮刀涂布法制备钙钛矿薄膜［J］. 中国光学, 2019,12(5):1028-1039.

[2] BAENA J P C,STEIER L,TRESS W,et al.. Highly efficient planar perovskite solar cells through band alignment engineering ［J］. Energy Environ. Sci., 2015,8(10):2928-2934.

[3] TAN Z K,MOGHADDAM R S,LAI M L,et al.. Bright light-emitting diodes based on organometal halide perovskite ［J］. Nat. Nanotechnol., 2014,9(9):687-692.

[4] SALIBA M,WOOD S M,PATEL J B,et al.. Structured organic-inorganic perovskite toward a distributed feedback laser ［J］. Adv. Mater., 2016,28(5):923-929.

[5] DONG R,FANG Y J,CHAE J,et al.. High-gain and low-driving-voltage photodetectors based on organolead triiodide perovskites ［J］. Adv. Mater., 2015,27(11):1912-1918.

[6] 张猛,张帆,张华野,等. Cs掺杂的高性能(NH2CH=NH2)1-x-CsxPbI3光电探测器［J］. 发光学报, 2018,39(11):1613-1620.

[7] ZHOU J C,HUANG J. Photodetectors based on organic-inorganic hybrid lead halide perovskites ［J］. Adv. Sci., 2018,5(1):1700256-1-24.

[8] JELLICOE T C,RICHTER J M,GLASS H F J,et al.. Synthesis and optical properties of lead-free cesium tin halide perovskite nanocrystals ［J］. J. Am. Chem. Soc., 2016,138(9):2941-2944.

[9] PARK K,LEE J W,KIM J D,et al.. Light-matter interactions in cesium lead halide perovskite nanowire lasers ［J］. J. Phys. Chem. Lett., 2016,7(18):3703-3710.

[10] ZHANG D D,EATON S W,YU Y,et al.. Solution-phase synthesis of cesium lead halide perovskite nanowires ［J］. J. Am. Chem. Soc., 2015,137(29):9230-9233.

[11] SHI Z F,LI Y,ZHANG Y T,et al.. High-efficiency and air-stable perovskite quantum dots light-emitting diodes with an all-inorganic heterostructure ［J］. Nano Lett., 2017,17(1):313-321.

[12] SHI Z F,LI Y,LI S,et al.. Localized surface plasmon enhanced all-inorganic perovskite quantum dot light-emitting diodes based on coaxial core/shell heterojunction architecture ［J］. Adv. Funct. Mater., 2018,28(20):1707031.

[13] SHI Z F,LI S,LI Y,et al.. Strategy of solution-processed all-inorganic heterostructure for humidity/temperature-stable perovskite quantum dot light-emitting diodes ［J］. ACS Nano, 2018,12(2):1462-1472.

[14] ZHUANG S W,MA X,HU D Q,et al. Green perovskite light emitting diodes based on the ITO/Al2O3/CsPbBr3 heterojunction structure ［J］. Opt. Mater., 2018,77:25-29.

[15] ZHUANG S W,MA X,HU D Q,et al. Air-stable all inorganic green perovskite light emitting diodes based on ZnO/CsPbBr3/NiO heterojunction structure ［J］. Ceram. Int., 2018,44(5):4685-4688.

[16] 王兰,董渊,高嵩,等. 钙钛矿材料在激光领域的研究进展［J］. 中国光学, 2019,12(5):993-1014.

[17] BURSCHKA J,PELLET N,MOON S J,et al.. Sequential deposition as a route to high-performance perovskite-sensitized solar cells ［J］. Nature, 2013,499(7458):316-319.

[18] LIU M Z,JOHNSTON M B,SNAITH H J. Efficient planar heterojunction perovskite solar cells by vapour deposition ［J］. Nature, 2013,501(7467):395-398.

[19] 刘娜,樊哲一,任杰灵,等. 蒸汽辅助溶液过程制备钙钛矿材料及钙钛矿太阳能电池［J］. 中国光学, 2017,10(5):568-577.

[20] 刘欢,毕文涛,高逢强,等. MA0.6Cs0.4PbBr3钙钛矿发光二极管瞬态电致发光研究［J］. 发光学报, 2019,40(1):89-96.

[21] 曹丽娟,江从彪,罗宇,等. 低启亮电压全溶液加工量子点发光器件［J］. 液晶与显示, 2020,35(8):785-794.

[22] 余彬海,卢汉光,饶龙石,等. 微通道反应器合成高质量的无机钙钛矿量子点及其LED应用［J］. 发光学报, 2018,39(4):440-448.

[23] 岑婉莹,樊婷,吕健滔,等. 铯铅溴量子点的合成与发光性质［J］. 发光学报, 2017,38(11):1457-1460.

[24] PROTESESCU L,YAKUNIN S,BODNARCHUK M I,et al.. Nanocrystals of cesium lead halide perovskites (CsPbX3,X= Cl,Br,and I):novel optoelectronic materials showing bright emission with wide color gamut ［J］. Nano Lett., 2015,15(6):3692-3696.

[25] 陈肖慧,季思航,袁曦,等. Mn掺杂CsPbCl3钙钛矿量子点的发光性质［J］. 发光学报, 2018,39(5):609-614.

[26] 袁海东,周龙,苏杰,等. 基于第一性原理的钙钛矿材料空位缺陷研究［J］. 中国光学, 2019,12(5):1048-1056.

[27] 耿卫东,郭嘉,唐静,等. 全无机胶体量子点显示技术［J］. 液晶与显示, 2014,29(4):479-484.

[28] LI X M,WU Y,ZHANG S L,et al.. CsPbX3 quantum dots for lighting and displays:room-temperature synthesis,photoluminescence superiorities,underlying origins and white light-emitting diodes ［J］. Adv. Funct. Mater., 2016,26(15):2435-2445.

[29] SUN S B,YUAN D,XU Y,et al.. Ligand-mediated synthesis of shape-controlled cesium lead halide perovskite nanocrystals via reprecipitation process at room temperature ［J］. ACS Nano, 2016,10(3):3648-3657.

[30] LI G P,WANG H,ZHANG T,et al.. Solvent-polarity-engineered controllable synthesis of highly fluorescent cesium lead halide perovskite quantum dots and their use in white light-emitting diodes ［J］. Adv. Funct. Mater., 2016,26(46):8478-8486.

[31] BEKENSTEIN Y,KOSCHER B A,EATON S W,et al.. Highly luminescent colloidal nanoplates of perovskite cesium lead halide and their oriented assemblies ［J］. J. Am. Chem. Soc., 2015,137(51):16008-16011.

[32] 马雪,庄仕伟,韩丽锦,等. 合成及薄膜制备条件对CsPbBr3全无机钙钛矿量子点特性的影响［J］. 发光学报, 2019,40(8):949-955.

韩丽锦, 马雪, 张源涛, 董鑫, 吴国光, 张宝林. 醋酸铯合成CsPbBr₃全无机钙钛矿量子点及薄膜发光特性[J]. 发光学报, 2020, 41(11): 1367. HAN Li-jin, MA Xue, ZHANG Yuan-tao, DONG Xin, WU Guo-guang, ZHANG Bao-lin. Luminescence Properties of all Inorganic Perovskite CsPbBr₃ Quantum Dots and Film Synthesized by Cesium Acetate[J]. Chinese Journal of Luminescence, 2020, 41(11): 1367.

醋酸铯合成CsPbBr₃全无机钙钛矿量子点及薄膜发光特性

关于本站 Cookie 的使用提示

全站搜索

醋酸铯合成CsPbBr3全无机钙钛矿量子点及薄膜发光特性

相关论文

相关资讯

关于本站 Cookie 的使用提示

全站搜索

醋酸铯合成CsPbBr₃全无机钙钛矿量子点及薄膜发光特性