Generation of high-energy neutrons with the 300-ps-laser system PALS Download: 750次
1. Introduction
Recent rapid development of laser plasma accelerators has made it possible to accelerate protons and deuterons to high energies of approximately 70 and 170 MeV, respectively[1, 2]. These beams hitting a secondary target can create high-energy neutrons through, for example, , , , , and nuclear reactions[2–15]. Fast neutrons with energies in excess of 10 MeV resulting from the reaction () have been reported by several authors[6–11]. Acceleration of deuterons is mostly reported in experiments using lasers with intensities of . The deuterons are accelerated in focal spots on thin-film targets through either the target-normal sheath acceleration (TNSA) mechanism or the newly recognized break-out afterburner (BOA) mechanism[2]. There is another laser ignition of fusion (LIF) scheme for applications, based on the combination of ultra-high laser nonlinear force driven plasma blocks and the relativistic acceleration of ion blocks, which has shown how 70 MeV and ions can be produced using of ps-laser pulses[16]. The laser-driven bright sources of neutrons can be used in fusion material research[2, 11, 17] and proton beams in medical disciplines as hadron therapy for the treatment of cancer[18].
Fig. 1. (a) Diagram of the dual target configuration. (b) Configuration of scintillation detectors N1 to N5 around the target chamber.
In contrast to ultra-short high-intensity lasers which allow the generation of beams of protons and deuterons possessing kinetic energies , sub-nanosecond lasers of the kJ-class capable of delivering a moderate intensity onto a target make it possible to accelerate ions up to MeV energies per nucleon[19–22]. The clear-cut evidence that the fastest protons accelerated by the laser system PALS (, 300 ps, ) have energies up to [20, 21] creates a way to accelerate a high number of deuterons from the front side of a target and exploit them in the production of high-energy () neutrons through the nuclear reaction even if the mean kinetic energy of the bunch of deuterons is 1 MeV. In addition, under these conditions up to neutrons per laser shot have be generated with the laser system PALS through the reaction, which is scalable with energy of other laser systems[22]. This scheme is applicable to newly developed high-energy-class cryogenically cooled multi-slab laser systems, allowing the production of a plasma with intensity [23].
A common phenomenon observed in experiments is the acceleration of protons coming from a contaminant layer on the irradiated surface of the target. The protons accelerated by the laser system PALS have a broad energy spectrum around a mean value of 2.5 MeV. Although the total cross section for neutron production through the reaction is only about three times lower than that for the reaction[6], the neutron yield from the reaction should be insignificant due to the very low content of protons in the produced plasma. Moreover, the peculiarity of the reaction that for proton kinetic energies just above the production threshold the emitted neutrons are kinematically focused into a cone in the direction of the proton beam makes it difficult to distinguish them among other neutrons because of the very large divergence angle of the proton beam.
In the experiment reported, a single planar deuterated polyethylene target was irradiated with the PALS laser, resulting in the production of neutrons through the , nuclear reactions, as well as in acceleration of deuterons that were capable of initiating the reaction in a secondary LiF catcher target.
2. Experimental arrangement
A deuterated polyethylene target of 0.2 mm in thickness was exposed to a laser intensity of aapproximately with the fundamental wavelength of delivered by the laser system PALS. The laser beam struck the target parallel to the target surface normal. The accelerated deuterons impacted a 1-mm-thick natural LiF slab with a surface area of , which was positioned 10 cm off the primary target, as Figure
Fig. 2. (a) Typical time-resolved ion current density observed using an IC positioned at a distance of 1.5 m from a massive target in a backward direction at with respect to the laser vector. The first peak was induced by XUV radiation. The peak at 70 ns was induced by 2.4 MeV protons. (b) Charge density of ions impacting on a secondary target at a distance of 10 cm for the primary target, which was derived from the IC signal using the relationship (2 ). The dashed line shows the energy of deuterons. The laser irradiance on target was .
3. Results and discussion
When a thick foil target is irradiated with the PALS laser, neutrons are generated via and nuclear reactions[22]. The neutron yield per energy reaches a value up to for an average laser energy of 550 J. This value equals the highest efficiency values observed at laser–solid interactions driven by high laser intensities ranging from to . Besides the neutrons, the laser-produced plasma emits fast ions having energies of MeV, as Figure
Fig. 3. Scintillation detector signal induced by emission of radiation and neutrons produced via , , and nuclear reactions. The emission was observed in the radial direction N3 (see Figure 1 ) at a distance of 230 cm from the target (shot #44511).
Using a similarity relationship for detected by identical detectors placed at two different distances and in the same direction[26]
Fig. 4. (a) Geometry of a nuclear reaction in the laboratory frame in which an incident deuteron with energy impinges on a Li atom of the stationary LiF target and angular distribution of the neutron energy calculated for a value of the reaction. (b) Deuteron energy dependence of the energy of d–Li neutrons detected in chosen directions as calculated using formula (1) in [10] describing the kinematics of neutron production in binary collisions between a projectile and an atom in a stationary target.
A typical signal of the scintillation detector that is induced by radiation and neutrons coming from nuclear reactions , , is shown in Figure
In contrast to the zero time coordinate for neutrons from the and reactions, which is related to the TOF of gamma radiation, the determination of the start time of neutrons produced via the reaction is encumbered by uncertainty caused by the broadband TOF spectrum of deuterons impinging on the LiF catcher target. A way to minimize this uncertainty consists of calculations of flight times of deuterons to the LiF catcher target and flight times of D–Li neutrons to the scintillation detectors. The value of can be determined using formulae describing the kinematics of neutron production in binary collisions between a projectile and an atom in a stationary target, such as those derived and discussed in[10, 29]. The dependence of neutron energy on the energy of deuterons and on the direction of observation is shown in Figure
Figure
Fig. 5. Deuteron energy dependence of the neutron arrival time at detectors N1–N5 (see Figure 4 ) related to the laser–target interaction. The distances from the catcher LiF target to the scintillation detectors were , , and .
Fig. 6. Scintillation detector signals observed in directions N1 to N5 ranging from to with respect to the mean direction of deuterons impinging on the LiF target and at distances from 0.8 to 2.4 m (see Figures 1 and 5 ).
Figure
Sorting of the peaks in the scintillation detector signals indicates that the repetitive bursts observed in the emission of fast ions in sub-nanosecond laser–solid experiments[22] may give rise to bursts in emission of fast neutrons generated via the beam–target reaction. Clear evidence is given by the observed well-separated maxima, for example at 52 and 59 ns in the N1 signal, and also at 60 and 78 ns in the N4 signal, that correlate well with the peaks of 200 and 400 keV deuterons appearing in the time dependence of the ion charge density (see Figure
The energy of the observed neutrons depends not only on the kinetic energy of fusing deuterons, but also on the direction of observation. Most of the neutrons emitted in the forward direction with respect to the direction of impinging deuterons have energy . Only a minority of them can reach 16 MeV energy. The maximum neutron yield from both the primary and secondary reactions was neutrons per shot. The partial contributions of both the and reactions can be estimated from the scintillation detector signal, by taking into account the dependence of the scintillation intensity on the energy deposited by neutrons. If we consider the solid angle of the expanding plasma plume containing the fast deuterons[25] reduced by the solid angle of the laser beam, because the deuterons are emitted from the front target surface, the possible maximum yield could be as high as . This value is more or less comparable to the value of of the nuclear reaction driven by an intensity of[7]. In that work the deuterons were produced using the Titan laser (energy 360 J and pulse length 9 ps) and accelerated from the rear surface of the foil through the TNSA mechanism. It follows from this comparison that different power-law relations govern both the experiments. Moreover, the similarity parameter does not also fully scale the generation of DD neutrons driven by high-power lasers with femtosecond to nanosecond pulse durations[22]. Thus, not only the laser intensity, but also the nonlinear phenomena occurring affect the laser energy absorption by the generated plasma and, thus, the ion acceleration.
Both the analysis of the N-TOF spectra and time-resolved ion charge density of the produced ions have shown that deuterons induced the nuclear reaction while possessing kinetic energy . Under these conditions the neutron source becomes isotropic[6]. A number of neutron detectors used contemporaneously at various directions and distances allow an evaluation of the anisotropy in the neutron emission. Nevertheless, our previous measurement of fusion neutron spectra outside the plasma focus device PF-1000 demonstrated the significant influence of the plasma vessel on the primary spectrum of generated neutrons[30]. Considering also shot-to-shot fluctuations in the ion emission[31], more complex laboratory equipment is needed to measure anisotropy in neutron emission through the beam–target reaction.
4. Conclusions
The deuterons generated on the front side of a thick foil exposed to an intensity of using the PALS laser system were exploited as drivers of the nuclear fusion reaction. The deuterons accelerated in the backward direction impinged on a LiF secondary target with an energy of 200–400 keV and produced D–Li neutrons with energies 14 MeV. Since only a small fraction of fast deuterons were hitting the LiF catcher target used, the maximum yield of D–D and D–Li neutrons was , which gives the normalized yield of . This value should still increase when increasing the area of the LiF target catcher.
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
[12]
[13]
[14]
[15]
[16]
[17]
[18]
[19]
[20]
[21]
[22]
[23]
[24]
[25]
[26]
[27]
[28]
[29]
[30]
[31]
J. Krasa, D. Klir, A. Velyhan, E. Krousky, M. Pfeifer, K. R ezac, J. Cikhardt, K. Turek, J. Ullschmied, K. Jungwirth. Generation of high-energy neutrons with the 300-ps-laser system PALS[J]. High Power Laser Science and Engineering, 2014, 2(3): 03000e19.