强激光与粒子束, 2012, 24 (9): 2125, 网络出版: 2012-09-12  

聚苯乙烯多孔薄膜的密度梯度控制

Control of density gradient in polystyrene porous films
作者单位
中国工程物理研究院 激光聚变研究中心, 四川 绵阳 621900
摘要
利用单分散的SiO2微球自组装制备了含一种尺寸微球的SiO2胶体晶体和含多种尺寸微球的多层异质结构。对含一种尺寸微球的SiO2胶体晶体进行煅烧和刻蚀处理后,胶体晶体中空隙所占比例大于立方密堆结构的26%,形成了非密堆结构,而且刻蚀时间越长,空隙比例越大。在同样的热处理和刻蚀条件下,微球尺寸越小的胶体晶体被刻蚀的程度越高,结构中空气空隙所占的比例越大。对SiO2多层异质结构经过煅烧和刻蚀处理后,得到了空隙梯度变化的多层结构,以此为模板制备了密度梯度变化的聚苯乙烯多孔薄膜。薄膜各层之间形成了平滑的过渡,没有显示出明显的层间缺陷,且孔与孔之间没有出现3维有序多孔结构中常见的大的连通孔道。
Abstract
Silica colloidal crystals and multilayer heterostructures were fabricated by using monodisperse silica microspheres. Non-closely-packed colloidal crystals, whose volume ratio of voids was larger than 26% in face-centered closely-packed structure, were obtained after calcining and etching silica colloidal crystals sequentially. The volume ratio of voids increases as the etching time is prolonged. It was found that the smaller the spheres forming colloidal crystals were, the bigger the ratio of voids was, after colloidal crystals were etched under the same condition. Graded silica colloidal films were obtained by calcining and etching silica multilayer heterostructures, which were used as templates to prepare polystyrene porous films with graded density. The different layers in porous films displayed a smooth transition where there were no obvious interlayer defects. Moreover, there were no large channels between pores that existed in conventional three-dimensionally ordered porous structures.
参考文献

[1] 宦春花, 温变英. 梯度功能材料表征技术研究进展[J]. 材料导报, 2010, 24(1):181-185.(Huan Chunhua, Wen Bianying. Development of characterization techniques for functionallly gradient materials. Materials Review, 2010, 24(1):181-185)

[2] Lobatchev V, Betti R. Ablative stabilization of the deceleration phase rayleigh-taylor instability[J]. Phys Rev Lett, 2000, 85(21):4522-4525.

[3] Colombant D, Schmitt A, Obenschain S, et al. Direct-drive laser target designs for sub-megajoule energies[J]. Phys Plasmas, 2007, 14: 056317.

[4] 叶文华, 张维岩, 陈光南, 等. 激光烧蚀瑞利-泰勒不稳定性数值研究[J]. 强激光与粒子束, 1999, 11(5):613-618.(Ye Wenhua, Zhang Weiyan, Chen Guangnan, et al. Numerical study of laser ablative Rayleigh-taylor instability. High Power Laser and Particle Beams, 1999, 11(5):613-618)

[5] Amendt P. Bell-Plesset effects for an accelerating interface with contiguous density gradients[J]. Phys Plasmas, 2006, 13:042702.

[6] Mikaelian K O. Approximate treatment of density gradients in Rayleigh-Taylor instabilities[J]. Phys Rev A, 1986, 33(2):1216-1222.

[7] Fujioka S, Shiraga H, Nishikino M, et al. First observation of density profile in directly laser-driven polystyrene targets for ablative Rayleigh-Taylor instability research[J]. Phys Plasmas, 2003, 10(12):4784-4789.

[8] Stber W, Fink A, Bohn E. Controlled growth of monodisperse silica spheres in the micron size range[J]. Journal of Colloid and Interface Science, 1968, 26(1):62-69.

[9] Jiang Peng, Hwang K S, Mittleman D M, et al. Template-directed preparation of macroporous polymers with oriented and crystalline arrays of voids[J]. Journal of the American Chemical Society, 1999, 121(50):11630-11637.

严鸿维, 张林, 吕海兵, 袁晓东, 任洪波. 聚苯乙烯多孔薄膜的密度梯度控制[J]. 强激光与粒子束, 2012, 24(9): 2125. Yan Hongwei, Zhang Lin, Lü Haibing, Yuan Xiaodong, Ren Hongbo. Control of density gradient in polystyrene porous films[J]. High Power Laser and Particle Beams, 2012, 24(9): 2125.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!