半导体光电, 2015, 36 (2): 275, 网络出版: 2015-06-25  

低噪声高带宽模拟光电探测器的设计和制作

Design and Fabrication of Analogical Photodetectors with Low Noise and High Bandwidth
作者单位
北京交通大学 光信息科学与技术研究所, 发光与光信息技术教育部重点实验室, 北京 100044
摘要
分析了交直流同时响应的模拟光电探测器设计和制作中的关键问题, 与电压差分光电探测电路相比, 电流差分电路具有工作点始终稳定在零点、有效抵消PIN的噪声电流, 以及无负载电阻的热噪声等优点, 并找到了电流差分电路工作的最佳条件, 制作了探测波长范围为900~1700nm的模拟光探测器, 其信噪比优于35dB, 最小可探测光强为200nW, 响应度为700V/W, 响应带宽达到0~70MHz。
Abstract
The key problems in the design of AC/DC response of photoelectric detector were analyzed. Compared with the voltage difference circuit, the current difference circuit owns such advantages as the operating point always stablizing at zero, suppressing the noise curent of PIN effectively and without the thermal noise of load resistance. Then based on finding the best operation conditions of current difference circuit, an analogical detector with the detection range of 900~1700nm was fabricated, with the signal-to-noise ratio of better than 35dB, the minimum detectable light intensity of 200nW, the responsibility of 700V/W, and the 3dB bandwidth of 0~70MHz.
参考文献

[1] 刘欢艳.超高速光接收机前端放大电路的设计[D].南京: 东南大学, 2003.

[2] 敖育红.光通信系统中前置跨阻放大器的研究和设计[J].微电子技术, 2003, 31(6):31-33.

[3] 郑锐.15Gb/s CMOS单片集成并行传输光接收前端放大器的设计[D].南京: 东南大学, 2006.

[4] 王春华, 周玲.一种新的高频差分电流缓冲放大器[C]//广西(南宁): 第十八届电工理论学术年会, 2006:115-119.

[5] 田俊.CMOS 1.4THzΩ 155Mb/s光接收机差分跨阻前置放大器[J].半导体学报, 2004,25(11):1486-1490.

[6] 张小军.1.25Gb/s光接收机前置放大器的设计[D].哈尔滨: 哈尔滨工业大学, 2007.

[7] 吴重庆.光通信导论[M].北京: 清华大学出版社, 2008:154-156.

[8] 胡涛, 司汉英.光电探测器前置放大电路设计与研究[J].光电技术应用, 2010, 25(1):52-55.

[9] 王梦莹,宋奋韬, 铁铮. 高频光电探测器的信号处理电路设计[J]. 机械与电子, 2012(23): 105-142.

[10] 田广锟.高速电路PCB设计与EMC技术分析[M]. 北京:电子工业出版社, 2008.

邱敏, 吴重庆, 李善勇, 王智. 低噪声高带宽模拟光电探测器的设计和制作[J]. 半导体光电, 2015, 36(2): 275. QIU Min, WU Chongqing, LI Shanyong, WANG Zhi. Design and Fabrication of Analogical Photodetectors with Low Noise and High Bandwidth[J]. Semiconductor Optoelectronics, 2015, 36(2): 275.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!