A304不锈钢NdYAG激光焊光致等离子体电信号频谱分析

杨瑞霞; 杨立军; 刘桐; 赵圣斌

doi:doi:10.3788/cjl201643.0802008

中国激光, 2016, 43 (8): 0802008, 网络出版: 2016-08-10

A304不锈钢NdYAG激光焊光致等离子体电信号频谱分析下载： 647次

Spectral Analysis of Laser Induced Plasma Electrical Signals from NdYAG Laser Welding of A304 Stainless Steels

论文大纲

杨瑞霞 ^1,*杨立军 ^1,2刘桐 ¹赵圣斌 ¹

作者单位

¹ 天津大学材料科学与工程学院, 天津 300072

² 天津大学天津市现代连接技术重点实验室, 天津 300072

激光技术激光焊接焊接模式频谱强度电信号等离子体 laser technique laser welding welding mode frequency spectrum intensity electrical signal plasma

AI 词云图 AI语音精读 AI语音超短摘要

注：本部分内容由 AI 自动生成，请您知悉。

摘要

利用无源电探针检测A304不锈钢在不同的NdYAG激光焊接条件下的光致等离子体电信号，研究了不同的激光焊接模式与激光等离子体电信号频谱分析结果之间的关系，分析了不同条件下的等离子体电信号波形图和频谱图，阐述了不同激光焊接模式下的焊缝横截面成形特征与等离子体电信号波形、频谱特征的关系。结果表明,在试验设定条件下，不同的激光焊接模式具有不同的等离子体电信号频谱特征。利用在500~1000 Hz范围内等离子体电信号频谱的谱强度E的大小可判别激光焊接过程是否为深熔焊，当E较大或超过一定值时，激光焊接模式为深熔焊。

Abstract

The electrical signals of laser induced plasma from NdYAG laser welding of A304 stainless steels are detected by a passive electrical probe. The relationship between different laser welding modes and the spectral analysis results of plasma electrical signals are investigated. The waveforms and spectra of plasma electrical signals are analyzed. The relationship between the formation characteristic of laser welds under different laser welding modes and the waveforms and spectra of the plasma electrical signals is illustrated. The results indicate that, under the specified conditions in the experiments, different laser welding modes correspond to different spectral characteristics of plasma electrical signals. Moreover, whether the welding mode is a deep penetration one or not can be identified by the spectral intensity E of plasma electrical signals within the scope of 500～1000 Hz. When E is large enough or exceeds a certain value, the laser welding mode is a deep penetration welding.

参考文献

[1] Szymanski Z, Hoffman J, Kurzyna J. Plasma plume oscillations during welding of thin metal sheets with a CW CO2 laser[J]. Journal of Physics D: Applied Physics, 2001, 34(2): 189-199.

[2] Kawahito Y, Matsumoto N, Mizutani M, et al. Characterisation of plasma induced during high power fibre laser welding of stainless steel[J]. Science and Technology of Welding and Joining, 2008, 13(8): 744-748.

[3] 骆红, 胡伦骥, 黄树槐, 等. 激光焊接质量的实时诊断和控制[J]. 激光与光电子学进展, 1997, 34(1): 1-6.

Luo Hong, Hu Lunji, Huang Shuhuai, et al. Real time diagnosis and control of laser welding quality[J]. Laser & Optoelectronics Progress, 1997, 34(1): 1-6.

[4] 李飞, 邹江林, 孔晓芳, 等. 高功率光纤激光-TIG复合焊接实验研究[J]. 中国激光, 2014, 41(5): 0503004.

Li Fei, Zou Jianglin, Kong Xiaofang, et al. Experimental research on high power fiber laser-TIG hybrid welding[J]. Chinese J Lasers, 2014, 41(5): 0503004.

[5] 郑世卿, 温鹏, 单际国. 激光热丝焊接过程焊丝过渡行为及其稳定性的研究[J]. 中国激光, 2014, 41(4): 0403008.

Zheng Shiqing, Wen Peng, Shan Jiguo. Research on wire transfer and its stability in laser hot wire welding process[J]. Chinese J Lasers, 2014, 41(4): 0403008.

[6] You D Y, Gao X D, Katayama S. Multiple-optics sensing of high-brightness disk laser welding process[J]. NDT&E International, 2013, 60: 32-39.

[7] Bi C, Yang L J, Xu W H, et al. An electrical detection of the fluctuating plasma of laser welding with a passive probe[J]. Journal of Physics D: Applied Physics, 2012, 45(38): 385202.

[8] 焦娇, 杨立军, 刘桐, 等. YAG激光焊接等离子体电信号检测与焊接模式分析[J]. 中国激光, 2014, 41(9): 0903005.

Jiao Jiao, Yang Lijun, Liu Tong, et al. Electrical detection of the plasma and analysis of welding modes in YAG laser welding[J]. Chinese J Lasers, 2014, 41(9): 0903005.

[9] Cherrington B E. The use of electrostatic probes for plasma diagnostics—A review[J]. Plasma Chemistry and Plasma Processing, 1982, 2(2): 113-140.

[10] 刘立群, 赵振南. 频谱分析技术在超声检测中的应用[J]. 一重技术, 2013(5): 57-61.

Liu Liqun, Zhao Zhennan. Spectrum analysis technique in ultrasonic test[J]. CFHI Technology, 2013(5): 57-61.

[11] 刘京雷, 陈彦宾, 徐庆鸿. 激光焊接声信号与熔深的相关性[J]. 焊接学报, 2006, 27(1): 72-75.

Liu Jinglei, Chen Yanbin, Xu Qinghong. Correlation of acoustic signals and weld depth in laser welding[J]. Transactions of the China Welding Institution, 2006, 27(1): 72-75.

[12] 肖荣诗, 陈铠, 陈继民, 等. CO2激光焊接光致等离子体屏蔽机制的实验研究[J]. 激光技术, 2001, 25(3): 238-241.

Xiao Rongshi, Chen Kai, Chen Jimin, et al. Experimental research of the plasma shielding mechanism in the process of CO2 laser welding[J]. Laser Technology, 2001, 25(3): 238-241.

[13] 邹江林, 李飞, 牛建强, 等. 高功率光纤激光焊接羽辉对焊接过程的影响[J]. 中国激光, 2014, 41(6): 0603005.

Zou Jianglin, Li Fei, Niu Jianqiang, et al. Effect of laser-induced plume on welding process during high power fiber laser welding[J]. Chinese J Lasers, 2014, 41(6): 0603005.

杨瑞霞, 杨立军, 刘桐, 赵圣斌. A304不锈钢NdYAG激光焊光致等离子体电信号频谱分析[J]. 中国激光, 2016, 43(8): 0802008. Yang Ruixia, Yang Lijun, Liu Tong, Zhao Shengbin. Spectral Analysis of Laser Induced Plasma Electrical Signals from NdYAG Laser Welding of A304 Stainless Steels[J]. Chinese Journal of Lasers, 2016, 43(8): 0802008.

A304不锈钢NdYAG激光焊光致等离子体电信号频谱分析下载： 647次

关于本站 Cookie 的使用提示

全站搜索

A304不锈钢NdYAG激光焊光致等离子体电信号频谱分析 下载： 647次

相关论文

相关资讯

关于本站 Cookie 的使用提示

全站搜索

A304不锈钢NdYAG激光焊光致等离子体电信号频谱分析下载： 647次