光学学报, 2006, 26 (2): 279, 网络出版: 2006-04-20   

光全息制作的变形面心立方结构光子晶体的带隙

Photonic Band Gap of the Distorted Face-Center-Cubic Structure Photonic Crystal Fabricated by Holographic Lithography
作者单位
中山大学光电材料和技术国家重点实验室, 广州 510275
摘要
四束激光从空气直接入射到平面结构的感光树脂所制备的面心立方结构实际上是一种不但晶格沿[111]方向拉伸,而且其格点也在[111]方向被拉长的变形面心立方结构。在对这种变形面心立方结构的光子晶体的晶格形状及能带分布的研究中,通过利用麻省理工学院的光子晶体能带计算程序计算了各种参量对此变形面心立方结构的蛋白石和反蛋白石的能带分布的影响,发现在一定条件下该结构的蛋白石会出现完全光子带隙。用激光全息聚合法在正胶的环氧树脂中可制作反蛋白石模板, 若用此模板制作硅蛋白石,当晶格沿[111]方向拉伸2.1倍和硅的占空比为13.7%时出现最大的带隙宽度。此最大带隙宽度的结构的制作光路是三角锥形光路,对称地环绕中央光束的三束外围激光束之间夹角为54.0°,三束外围激光束与中央激光束夹角为31.6°。
Abstract
The face-center-cubic structure obtained by four incident laser beams directly from air to photoresist of planar construction, is actually a kind of distorted face-center-cubic structure. Both of its lattices and its latticesites are lengthened along [111] direction. In the study on the lattice shape and band structure of this distorted face-center-cubic structure, using MIT's Photonic-Bands program, after calculating the relations between the energy band structure and all kinds of parameters of opal and inverse opal, a complete photonic band-gap in its opal structure is obtained. The largest photonic band-gap is obtained as the lengthening ratio is 2.1 and the filling ratio of silica is 13.7%. For fabrication of this structure with largest photonic band-gap by holographic lithography method, which needs two steps (fabrication of opal and fabrication of inverse opal by filling), the three outer beams are placed symmetrically around the central beam, the three outer beams are 54.0° apart, and the angles between the central beam and outer beams are 31.6°.
参考文献

[1] . Strong localization of photons in certain disordered dielectric superlattices[J]. Phys. Rev. Lett., 1987, 58(23): 2486-2489.

[2] . Inhibited spontaneous emission in solid-state physics and electronics[J]. Phys. Rev. Lett., 1987, 58(20): 2059-2062.

[3] Li Yanfeng, Hu Minglie, Wang Qingyue. Calculation and design of photonic crystal fibers with zero-dispersion wavelength at 800 nm[J]. Chin. J. Lasers, 2003, 30(5): 427~430 (in Chinese)
栗岩锋,胡明列,王清月. 800 nm处为零色散的光子晶体光纤的计算与设计[J]. 中国激光, 2003, 30(5): 427~430

[4] Zhu Zhihong, Ye Weimin, Yuan Xiaodong et al.. Photonic crystal waveguide directional coupler[J]. Acta Optica Sinica, 2003, 23(10): 1237~1240 (in Chinese)
朱志宏,叶卫民,袁晓东 等. 光子晶体波导定向耦合器[J]. 光学学报, 2003, 23(10): 1237~1240

[5] . Campbell, D. N. Sharp, M. T. Harrison et al.. Fabrication of photonic crystals for the visible spectrum by holographic lithography[J]. Nature, 2000, 404(6773): 53-56.

[6] Guangyong Zhou, Michael James Ventura, Min Gu. Two-dimensional near-infrared photonic crystal fabrication by generation of channels in solid resin[J]. Chin. Opt. Lett., 2003, 1(12): 719~721

[7] . Wang, J. F. Xu, H. M. Su et al.. Three-dimensional photonic crystals fabricated by visible light holographic lithography[J]. Appl. Phys. Lett., 2003, 82(14): 2212-2214.

[8] . V. Miklyaer, D. C. Meisel, A. Blanco et al.. Three-dimensional face-centered-cubic photonic crystal templates by laser holography: fabrication, optical characterization, and band-structure calculations[J]. Appl. Phys. Lett., 2003, 82(8): 1284-1286.

[9] . . Three-dimensional ordered patterns by light interference[J]. Opt. Lett., 1995, 20(5): 429-431.

朱少安, 钟永春, 汪河洲. 光全息制作的变形面心立方结构光子晶体的带隙[J]. 光学学报, 2006, 26(2): 279. 朱少安, 钟永春, 汪河洲. Photonic Band Gap of the Distorted Face-Center-Cubic Structure Photonic Crystal Fabricated by Holographic Lithography[J]. Acta Optica Sinica, 2006, 26(2): 279.

本文已被 4 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!