热容运转模式下LD泵浦固体激光器的热效应分析

岱钦; 乌日娜; 宁日波; 杜鹏远

光学精密工程, 2008, 16 (6): 1025, 网络出版: 2010-02-28

热容运转模式下LD泵浦固体激光器的热效应分析

Analysis of thermal effect of solid state lasers in heat capacity mode

论文大纲

岱钦 ^*乌日娜宁日波杜鹏远

作者单位

沈阳理工大学理学院,辽宁沈阳 110168

固体激光器热容运转模式热效应有限元分析 solid state laser heat capacity mode thermal effect finite element analysis

摘要

针对热容运转模式下的固体激光器,修正了二极管泵浦光强分布,并且考虑激光工作物质的比热容和热传导率随温度变化的特性,建立了三角均布脉冲LD侧面泵浦固体激光工作物质的热传导物理模型。利用有限元方法,模拟分析了激光工作物质的温度变化过程。结果表明,由于泵浦光的不均匀分布,热容运转模式下的固体激光器仍然会受到热效应的影响。分析比较了热容固体激光器和连续泵浦、脉冲泵浦模式下热稳态固体激光器工作物质的热效应,3种工作模式下,激光工作物质内的最大温差分别为3.59、35.51、8.07 K。表明热容运转模式下,激光工作物质内温度梯度非常小。讨论结果对热容激光器的设计工作提供了参考。

Abstract

A heat transmission model for YAG crystal of a side-pumping solid state laser with triangle uniform distribution was established based on heat capacity mode and considering the diode pumped light intensity distribution,specific heat capacity,thermal conductivity and the properties of YAG materials varied with temperature.The finite element method was used to simulate and analyze the temperature change of laser crystal media,analysed results indicate that YAG operated in heat capacity mode can be affected by thermal effect from asymmetric pumping light.The thermal effects of different YAGs including heat capacity model,continuous pumping and pulse pumping model were compared and analyzed,compared results show that the maximal temperature differences of the three models are 3.59、35.51 and 8.07 K,respectively,which suggests that the smallest temperature difference is at the heat capacity mode and the results can provide a reference for the design of heat capacity laser.

参考文献

[1] ALBRECTH G F,SUTTON S B,GEORGE E V,et al..Solid state heat capacity disk laser[J].Laser and Particle beams,1998,16(4):605-625

[2] SUN Z P,LI R N,BI Y,et al..Investigation on performance of high repetition diode-pumped heat-capacity Nd:YAG laser[J].Chin.Phys.Lett.,2005,22(2):339-342

[3] 蔡震,胡浩,蒋建峰,等.300 W二极管泵浦固体热容激光器[J].强激光与粒子束,2005,17(增):49-52.CAI ZH,HU H,JIANG J F,et al..300 W diode-pumped solid state heat capacity laser[J].High Power Laser and Particle Beams,2005,17(Supp.):49-52

[4] 彭钦军,薄勇,杨晓东,等.2 277 W全固态热容激光器[J].中国激光,2005,32(11):1477.PENG Q J,BO Y,YANG X D,et al..A 2 277 W solid state heat capacity laser[J].Chinese Journal of Lasers,2005,32(11):1477

[5] 蔡震,胡浩,蒋建峰,等.千瓦级激光二极管抽运热容固体激光器[J].中国激光,2006,33(2):153-156.CAI ZH,HU H,JIANG J F,et al..Kilowatt class laser diodes-pumped solid state heat capacity Laser[J].Chinese Journal of Lasers,2006,33(2):153-156

[6] 刘列,许晓军,杨建坤,等.基于火花隙开关实现的固体热容激光器实验[J].强激光与粒子束,2005,17(6):845-848.LIU L,XU X J,YANG J K,et al..Experiments of solid state heat capacity laser using spark switch[J].High Power Laser and Particle Beams,2005,17(6):845-848

[7] HUCHITAL D A,STEINBERG G N.Pumping of Nd:YAG with electrodeless arc lamps[J].IEEE,1976,12(1):1-8

[8] ROESS D.Analysis of room temperature CW ruby lasers[J].IEEE,1966,2(8):208-214

[9] 丁丽明,杨福民,BOWMAN S R,等.聚光腔对光泵均匀性的影响[J].中国激光,1989,16(6):359-361.DING L M,YANG F M,BOWMAN S R,et al..Effect of condensers on the homogeneity of optical pumping[J].Chinese Journal of lasers,1989,16(6):359-361

[10] 朱广志,陈培锋,邹雪芬,等.侧面泵浦激光器热透镜效应的有限元分析[J].激光技术,2004,28(2):208-210.ZHU G ZH,CHEN P F,ZOU X F,et al..Finite element analysis of laser medium's thermal lens[J].Laser Technology,2004,28(2):208-210

[11] 汪晓波,许晓军,陆启生.固体棒状热容激光器的热分析[J].强激光与粒子束,2007,19(4):589-592.WANG X B,XU X J,LU Q SH.Dynamic temperature profiles in heat capacity laser rods[J].High Power Laser and Particle Beams,2007,19(4):589-592

[12] 宁继平,蔡志强,陈志强,等.LD侧面抽运的Nd:YAG激光器抽运均匀性研究[J].中国激光,2004,31(4):390-394.NING J P,CAI ZH Q,CHEN ZH Q,et al..Study on uniform of pump distributivity in a LD side-pumped Nd:YAG laser[J].Chinese Journal of Lasers,2004,31(4):390-395

[13] XIE W J,TAM S C,LAM Y L,et al..Influence of the thermal effect on the TEM00 mode output power of laser-diode side-pumped solid-state laser[J].Applied Optics,2000,39(30):5482-5487

[14] WEBER R,NEUENSCHWANDER B,WEBER H.P.Thermal effects in solid-state laser materials[J].Optical Materials,1999,11:245-254

[15] 岱钦,李新忠,王希军.YAG物理特性参数对LD泵浦固体激器热效应的影响[J].光子学报,2007,36(12):2201-2204.DAI Q,LI X ZH,WANG X J.Influence of YAG materials property on thermal effects in LD side pumping solid state lasers[J].Acta Rhotonica Sinica,2007,36(12):2201-2204

[16] BROWN D C.Nonlinear thermal distortion in YAG rod amplifiers[J].IEEE,1998,34(12):2383-2392

岱钦, 乌日娜, 宁日波, 杜鹏远. 热容运转模式下LD泵浦固体激光器的热效应分析[J]. 光学精密工程, 2008, 16(6): 1025. DAI Qin, WU Ri-na, NING Ri-bo, DU Peng-yuan. Analysis of thermal effect of solid state lasers in heat capacity mode[J]. Optics and Precision Engineering, 2008, 16(6): 1025.

热容运转模式下LD泵浦固体激光器的热效应分析

关于本站 Cookie 的使用提示

全站搜索

热容运转模式下LD泵浦固体激光器的热效应分析

相关论文

相关资讯

关于本站 Cookie 的使用提示

全站搜索