强激光与粒子束, 2011, 23 (6): 1487, 网络出版: 2011-07-04  

评估固体激光器对流换热系数的方法

Method to estimate surface heat transfer coefficient of solid-state laser
作者单位
1 中国工程物理研究院 激光聚变研究中心, 四川 绵阳 621900
2 国防科学技术大学 理学院, 长沙 410073
摘要
为提高固体激光器的热管理效果,提出了一种使用316L不锈钢片代替激光晶体评估固体激光器表面对流换热系数的方法。在低冷却水温的条件下,使用快响应热电偶对替代片和出口水流的动态温度进行测量,应用有限元方法计算不同对流换热系数下替代片的动态温度,讨论了对流换热系数对重频大能量激光器热效应的影响。通过寻找测量值和计算值的最小方差,得到该冷却结构下的激光器表面对流换热系数为3 500 W·m-2·K-1。
Abstract
This article proposes a simple method using a false crystal (316L steel) to estimate the surface heat transfer coefficient of solid-state laser. First we set a low cooling water temperature, measure the temperature evolution of outlet water and the false crystal with two thermal couples, and then we calculate temporal evolution of temperature with arbitrary heat transfer coefficient using finite element analysis. By searching the lowest least square difference between measurement and simulation, heat transfer coefficient is estimated finally. The impact of heat transfer coefficient in rep-rated and high-energy laser design is also presented.
参考文献

[1] Koechner W. Solid-state laser engineering[M]. Berlin: Springer Verlag, 2006: 358-359.

[2] Bonner R, Wadell R, Popov G. Local heat transfer coefficient measurements of flat angled sprays using thermal test vehicle[C]//24th IEEE Semiconductor Thermal Measurement and Management Symposium.2008: 149-153.

[3] Tawfek A. Heat transfer and pressure distributions of an impinging jet on a flat surface[J].Heat and Mass Transfer,1996,32(1): 49-54.

[4] Martin H, James P H, Thomas F I. Heat and mass transfer between impinging gas jets and solid surfaces[C]//Advances in Heat Transfer. 1977: 1-60.

[5] Incropera F, De Witt D. Fundamentals of heat and mass transfer[M].6th ed. New York: John Wiley and Sons, 2006.

[6] Peng Xiaoyuan, Xu Lei, Asundi A. Thermal lensing effects for diode-end-pumped Nd: YVO4 and Nd: YAG lasers[J].Optical Engineering,2004,43(10): 2454-2461.

[7] 王明哲, 李明中, 谭吉春, 等. 大口径 LD 泵浦的激光放大器热沉积特性[J].强激光与粒子束, 2006,18(12): 1979-1982.(Wang Mingzhe, Li Mingzhong, Tan Jichun, et al. Research on heat deposition in large-aperture diode-end-pumped laser amplifier.High Power Laser and Particle Beams,2006,18(12): 1979-1982)

[8] 欧群飞. 高功率二极管抽运固体激光器的热效应分析[D]. 成都: 四川大学, 2005.(Ou Qunfei. Analysis of thermal effects in high power diode pumped solid-state lasers. Chengdu: Sichuan University, 2005)

[9] 曹丁象. 高功率固体激光系统的热效应及热管理研究[D]. 长沙: 国防科学技术大学, 2008.(Cao Dingxiang. Study on thermal effects and thermal management in high power solid state lasers. Changsha: National University of Defense Technology, 2008)

[10] Chenais S, Forget S, Druon F, et al. Direct and absolute temperature mapping and heat transfer measurements in diode-end-pumped Yb: YAG[J].Applied Physics B: Lasers and Optics,2004,79(2): 221-224.

[11] 宋小鹿, 过振, 李兵斌, 等. 散热方式对激光晶体热畸变效应的影响[J].中国激光,2010,37(2): 351-367.(Song Xiaolu, Guo Zhen, Li Bingbin, et al. Influences of heat-dissipation methods on thermal distortion of laser rods.Chinese Journal of Lasers,2010,37(2): 351-367)

[12] Hein J, Podleska S, Siebold M, et al. Diode-pumped chirped pulse amplification to the joule level[J].Applied Physics B: Lasers and Optics,2004,79(4): 419-422.

王明哲, 郑建刚, 张永亮, 李明中, 严雄伟, 单小童, 蒋新颖, 景峰. 评估固体激光器对流换热系数的方法[J]. 强激光与粒子束, 2011, 23(6): 1487. Wang Mingzhe, Zheng Jian’gang, Zhang Yongliang, Li Mingzhong, Yan Xiongwei, Shan Xiaotong, Jiang Xinying, Jing Feng. Method to estimate surface heat transfer coefficient of solid-state laser[J]. High Power Laser and Particle Beams, 2011, 23(6): 1487.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!