光学 精密工程, 2017, 25 (11): 2872, 网络出版: 2018-01-17  

基于单次全反射椭球单玻璃管X射线聚焦镜表征光源参数

Determination of parameters of X-ray source based on single-bounce ellipsoidal monocapillary X-ray condenser
作者单位
1 北京师范大学 核科学与技术学院,北京 100875
2 北京市辐射中心,北京 100875
摘要
为了正确表征X射线光源参数,本文利用单次全反射椭球单玻璃管X射线聚焦镜,设计了一种测量X射线光源焦斑尺寸和焦深的方法。该方法利用椭球单玻璃管X射线聚焦镜具有单次全反射成像能力的特点,对多个已知焦斑尺寸的多毛细管X光透镜模拟光源的焦斑成像尺寸和椭球聚焦镜的面形误差进行表征,从而确定光源焦斑尺寸和经过椭球聚焦镜后的焦斑成像尺寸以及椭球聚焦镜的面型误差之间的通用数学关系。然后,通过分析待测光源焦斑经过椭球聚焦镜所成像的尺寸来得到被测量光源的焦斑尺寸。利用该法也同样可以得到光源焦深的大小。为了验证设计方法的可行性,测量了实验室微焦斑X射线光源的焦斑和焦深参数。测试显示: 对于焦斑直径约为50 μm、焦深约为20 mm的光源,文中方法得到的算术平均值标准偏差分别为1.5 μm和0.7 mm。结果表明: 本文设计的光源参数表征方法可以实现对微焦斑源焦斑尺寸和焦深的同时测量,在X射线源的研制和应用领域具有潜在应用。
Abstract
To exactly characterize X-ray light resource parameters, a measuring method for the focal spot size and focal depth of an X-ray source was proposed by using a single-bounce ellipsoidal monocapillary X-ray condenser (SBEMXRC). The SBEMXRC was a kind of X-ray reflective imaging optics and characterized by its single total reflection imaging capability. The universal relationship among the focal spot size of the X-ray source, image size of focal spot of the X-ray source and the slope errors of the SBEMXRC was determined by the X-ray sources with known spot sizes simulated by a polycapillary X-ray lens. The focal spot size of the X-ray source with a unknown spot size was accordingly obtained by analyzing image size of the focal spot. The focal depth of the X-ray source could also be measured by the designed method. To verify the feasibility of the designed method, the spot size and the focal depth of a microfocus X-ray source in our lab were measured. The experimental results show that the arithmetic mean standard deviations of the measurement are 1.5 μm and 0.7 mm for the X-ray source with a spot size about 50 μm and a focal depth about 20 mm, respectively. The results demonstrate that the focal spot size and focal depth of the X-ray source could be simultaneously measured with the designed method. This method has potential applications in the field of X-ray sources.
参考文献

[1] 侯榆青, 贾涛, 易黄建, 等. 基于改进谱投影梯度算法的X射线发光断层成像[J]. 光学 精密工程, 2017, 25(1): 42-49.

    HOU Y Q, JIA T,YI H J, et al.. X-ray luminescence computed tomography based on improved spectral projected gradient algorithm [J]. Opt. Precision Eng., 2017, 25(1): 42-49. (in Chinese)

[2] 张海波, 耿国华, 易黄建, 等. X射线发光断层成像中笔束与锥束激发性能的对比[J]. 光学 精密工程, 2016, 24(5): 986-992.

    ZHANG H B, GENG G H, YI H J, et al.. Comparison between pencil-beam and cone-beam in XLCT System [J]. Opt. Precision Eng., 2016, 24(5): 986-992. (in Chinese)

[3] 高向东, 李竹曼, 游德勇, 等. 激光焊匙孔特征的近红外与X射线传感分析[J]. 光学 精密工程, 2016, 24(10): 2400-2407.

    GAO X D, LI ZH M, YOU D Y, et al.. Analysis of laser welding keyhole characteristics based on near-infrared high speed camera and X-ray sensing [J]. Opt. Precision Eng., 2016, 24(10): 2400-2407. (in Chinese)

[4] 郭清江, 王大椿. 针孔成象的针孔效应[J]. 原子能科学技术, 1980, 14(4): 385-386.

    GUO Q J, WANG D CH, The pinhole of pinhole imaging effect [J]. Atomic Energy Science and Technology, 1980, 14(4): 385-386. (in Chinese)

[5] 李勤, 石金水, 禹海军, 等. 狭缝法测量X射线斑点大小[J]. 强激光与粒子束, 2006, 18(10): 1691-1694.

    LI Q, SHI J SH, YU H J, et al.. Slit X-ray spot size measurement technique [J]. High Power Laser and Particle Beams, 2006, 18(10): 1691-1694. (in Chinese)

[6] 孙天希, 丁训良, 刘志国, 等. 利用多毛细管准直器测量X射线光源焦斑尺寸[J]. 原子能科学技术, 2008, 42(7): 633-636.

    SUN T X, DING X L, LIU ZH G, et al.. Measurements of focal spot size for X-ray source by using polycapillary collimator [J]. Atomic Energy Science and Technology, 2008, 42(7): 633-636. (in Chinese)

[7] ROMANOV A Y. Measurement of the parameters of the focal spot of an X-ray Tube using Kumakhov optics [J]. Measurement Techniques, 2004, 47(7): 670-674.

[8] ROEMER D. X-ray fluorescence with doubly curved crystal optics [D]. New York, USA: University of Albany of State University of New York, 2007.

[9] SUN X P, LIU ZH G, SUN T X, et al.. Combined optic system based on polycapillary X-ray optics and single-bounce monocapillary optics for focusing X-rays from a conventional laboratory X-ray source [J]. Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2015, 802: 5-9.

[10] SUN X P, LIU ZH G, YI L T, et al.. Adjustable hollow-cone output X-ray beam from an ellipsoidal monocapillary with a pinhole and a beam stop [J]. Applied Optics, 2015, 54(35): 10326-10332.

[11] ZENG X H, DUEWER F, FESER M, et al.. Ellipsoidal and parabolic glass capillaries as condensers for X-ray microscopes [J]. Applied Optics, 2008, 47(13): 2376-2381.

[12] JIANG B W, LIU ZH G, SUN X P, et al.. Single bounce ellipsoidal glass monocapillary condenser for X-ray nano-imaging [J]. Optics Communications, 2017, 398: 91-94.

[13] SUN T X, DING X L. Measurements of energy dependence of properties of polycapillary X-ray lens by using organic glass as a scatterer [J]. Journal of Applied Physics, 2005, 97(12): 124904.

[14] HUANG R, BILDERBACK D H. Single-bounce monocapillaries for focusing synchrotron radiation: modeling, measurements and theoretical limits [J]. Journal of Synchrotron Radiation, 2006, 13(1): 74-84.

[15] HUANG R, BILDERBACK D H. Simulation of microfocused image size from a one-bounce glass capillary [J]. Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2001, 467-468: 978-981.

[16] SNIGIREV A, BJEOUMIKHOV A, ERKO A, et al.. Submicrometer hard X-ray focusing using a single-bounce ellipsoidal capillary combined with a Fresnel zone plate [J]. Journal of Synchrotron Radiation, 2007, 14(2): 227-228.

[17] SUN T X, DING X L. Confocal X-ray technology based on capillary X-ray optics [J]. Reviews in Analytical Chemistry, 2015, 34(1-2): 45-59.

[18] SUN T X, DING X L. Study on the measurement of properties of polycapillary X-ray lens [J]. Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2004, 226(4): 651-658.

王亚冰, 朱玉, 孙天希, 孙学鹏, 刘志国, 李坊佐, 姜博文, 张晓芸, 张丰收. 基于单次全反射椭球单玻璃管X射线聚焦镜表征光源参数[J]. 光学 精密工程, 2017, 25(11): 2872. WANG Ya-bing, ZHU Yu, SUN Tian-xi, SUN Xue-peng, LIU Zhi-guo, LI Fang-zuo, JIANG Bo-wen, ZHANG Xiao-yun, ZHANG Feng-shou. Determination of parameters of X-ray source based on single-bounce ellipsoidal monocapillary X-ray condenser[J]. Optics and Precision Engineering, 2017, 25(11): 2872.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!