光学窗口材料激光辐照热力效应的解析计算研究

黄峰; 牛燕雄; 汪岳峰; 段晓峰

光学学报, 2006, 26 (4): 576, 网络出版: 2006-05-17

光学窗口材料激光辐照热力效应的解析计算研究

Calculation of Thermal and Mechanical Effect Induced by Laser in Optical Window Materials

论文大纲

黄峰 ^*牛燕雄汪岳峰段晓峰

作者单位

解放军军械工程学院光学与电子工程系, 石家庄 050003

摘要

建立了高功率连续激光辐照透明光学材料的热力学模型,通过积分变换方法求解三维热传导方程,得出了激光辐照引起的瞬态温度场分布的精确解析解,并在此基础上进一步求得热应力场的瞬态分布。以1.315 μm的高能氧碘激光辐照熔石英玻璃为例,计算了熔石英在激光辐照下的温度场与热应力场分布,分析了其激光损伤机理。研究结果表明由于熔石英具有优良的热稳定性,温度不均匀分布所产生的热应力相对较小,激光损伤主要是受辐照区域温度值超过材料熔点发生熔融破坏。理论分析结果与相关的实验结论一致,说明所建立激光辐照效应模型的合理性。

Abstract

The thermal-mechanical model of transparent optical materials induced by high-power continuous laser is set up and the precise resolution of transient temperature field distribution induced by laser is obtained through resolving the 3-dimensional heat conduction equation using integral-transform method. On the base of the above analysis, the thermal stress field transient distribution induced by laser is worked out. Taking fused silica irradiated by 1.315 μm high-power chemical oxygen-iodine laser (COIL) as an example, the fused silica temperature field and thermalstress field transient distributions irradiated by COIL laser are calculated and the laser induced damage mechanism is analyzed further. The calculation result shows that the laser induced damage is mostly melt damage in the areas where temperature exceeds melt point of fused silica. Because fused silica has a fine thermal stability, the thermal stresses induced by the temperature ununiformity are small relatively. The theoretical analyzing result is in accordance with the relative experimental result, so the laser irradiation effect model proves correct.

参考文献

[1] Alberto Salleo. High-Power Laser Damage in Fused Silica[D]. Dissertation for the Ph. D. of University of California, Berkeley. 2001. 42～77

[2] Chris B. Schaffer. Interaction of Femtosecond Laser Pulse with Transparent Materials[D]. Dissertation for the Ph. D. of Harvard University 2001. 36～62

[3] F. Bonneau, P. Combis, G. Daral et al.. Laser induced damage simulation of silica surface under 1.053 μm irradiation[C]. Proc. SPIE, 2001, 4347: 560～568

[4] John H. Campbell, Patricia A. Hurst, Dwight D. Heggins et al.. Laser induced damage and fracture in fused silica vacuum windows[C]. Proc. SPIE, 1997, 2966: 106～125

[5] Yoshiro Ito, Satoshi Kiyoku, Tsutomu Ogura et al.. Dynamical observation of laser induced damage made in inside of transparent materials[C]. Proc. SPIE, 2002, 4426: 62～65

[6] . Damage mechanism of optical materials[J]. Progress in Physics, 1998, 18(2): 187-206.

[7] Sun Feng, Cheng Zuhai, Zhang Yaoning et al.. Thermal distortions in calcium fluoride, potassium chloride and fused silica windows at 1.315 μm[J]. Chin. J. Lasers, 2004, 31（4）: 412～416 (in Chinese)
孙峰,程祖海,张耀宁等. 在波长1.315 μm下的几种激光器窗口热效应比较研究[J]. 中国激光, 2004, 31（4）: 412～416

[8] Guo Shaofeng, Lu Qisheng, Cheng Xiangai et al.. Rotation effects of intensive laser window[J]. Chin. J. Lasers, 2004, 31（2）: 145～148 (in Chinese)
郭少锋,陆启生,程湘爱等. 激光器窗口的旋转效应[J]. 中国激光, 2004, 31（2）: 145～148

[9] M. N. zisik, Yu Changming trans. Heat Conduction[M]. Beijing: High Education Press, 1983. 596～615 (in Chinese)
M. N. zisik 著,俞昌铭译. 热传导[M]. 北京: 高等教育出版社,1983. 596～615

[10] Ping Xiuer. Thermal Stress and Thermal Fatigue[M]. Beijing: National Defence Industry Press, 1984. 12～30 (in Chinese)
平修二. 热应力与热疲劳[M]. 北京: 国防工业出版社,1984. 12～30

[11] . . CW laser induced thermal and mechanical damage in optical window materials[J]. Acta Optica Sinica, 1997, 17(1): 20-23.

黄峰, 牛燕雄, 汪岳峰, 段晓峰. 光学窗口材料激光辐照热力效应的解析计算研究[J]. 光学学报, 2006, 26(4): 576. 黄峰, 牛燕雄, 汪岳峰, 段晓峰. Calculation of Thermal and Mechanical Effect Induced by Laser in Optical Window Materials[J]. Acta Optica Sinica, 2006, 26(4): 576.

光学窗口材料激光辐照热力效应的解析计算研究

关于本站 Cookie 的使用提示

全站搜索

光学窗口材料激光辐照热力效应的解析计算研究

相关论文

相关资讯

关于本站 Cookie 的使用提示

全站搜索