光电工程, 2020, 47 (1): 190304, 网络出版: 2020-02-24   

自适应图像增强的管道机器人缺陷检测方法

Research on defect inspection method of pipeline robot based on adaptive image enhancement
作者单位
宁波大学机械工程与力学学院,浙江 宁波 315211
摘要
针对管道检测过程中图像采集光照不均匀、缺陷边缘提取不准确的问题,提出一种基于自适应图像增强的管道机器人缺陷检测方法。首先设计单尺度Retinex 自适应图像增强算法,利用引导滤波对图像进行照度分量估计,经自适应Gamma 矫正得到光照均衡图像,实现自适应图像增强;再对传统Canny 边缘检测方法进行改进,采用双边滤波平滑图像,通过迭代阈值法进行缺陷图像分割,根据边缘像素相似性进行连接,实现缺陷轮廓的有效提取。搭建基于自适应图像增强的管道机器人缺陷检测系统,利用履带式小车搭载云台摄像机,对管道内壁缺陷进行全方位视觉检测。实验结果表明,本文的检测方法可自适应矫正图像亮度,图像亮度不均匀明显改善,相比次优算法,图像信息熵提升2.4%,图像平均梯度提升2.3%,峰值信噪比提升4.4%,可有效提取出管道缺陷边缘,缺陷识别准确率达到97%。
Abstract
In view of the problem about uneven image acquisition and inaccurate edge extraction in pipeline detection process, a pipeline robot defect inspection method based on adaptive image enhancement is proposed. Firstly, a single-scale Retinex adaptive image enhancement algorithm is designed, which uses the guided filter to estimate the illumination component of the Value component of the image, and gets the illumination equilibrium image by adaptive Gamma correction, so as to realize the image enhancement. Then, the traditional Canny edge detection method is improved, using bilateral filtering to smooth the image. Besides, the defect images are segmented by the iterative threshold method, and the edge connection is carried out according to the edge pixel similarity. Therefore, the defect contour of the pipe-wall is extracted effectively. Thirdly, a pipeline robot defect detection system based on adaptive image enhancement is built, and a crawler car equipped with the pan-tilt-zoom camera conducts all-round visual inspection of the defects in the pipeline inner wall. The experimental results show that the detection method in this paper can adaptively correct the image brightness, and the uneven brightness of the image is significantly improved. Compared with the sub-optimal algorithm, the information entropy of the image is increased by 2.4%, the average gradient of the image is increased by 2.3%, and the peak signal to noise ratio is increased by 4.4%, and the pipeline defect edges are extracted effectively with the detection accuracy up to 97%.
参考文献

[1] Hong D H,Wang H L, Li W P, et al. Study on the defects in welded joint of hot reheat steam pipe of ultra supercritical units after long-term service[J]. Journal of Mechanical Engineering, 2017, 53(18): 113–120.洪鼎华, 王环丽, 李武平, 等. 在役 P92钢蒸汽管道焊接接头中缺陷的研究[J].机械工程学报, 2017, 53(18): 113–120.

[2] Yang X F, Wu Y Y, Zhao L. Pipeline crack detection algorithm based on Canny detector[J]. Computer Engineering and Design, 2018, 39(3): 798–803. 杨先凤, 吴媛媛, 赵玲. 基于 Canny改进算子的油管裂纹检测算法[J].计算机工程与设计, 2018, 39(3): 798–803.

[3] Sun L, Sun Q Q,Ren L, et al. A new method for underground pipeline corrosion monitoring applied FBG[J]. Acta Photonica Sinica, 2012, 41(1): 6–10.孙丽, 孙茜茜 , 任亮, 等. 应用光纤布喇格光栅传感器监测地下管道腐蚀的新方法研究[J].光子学报, 2012, 41(1): 6–10.

[4] Cao J S, Cao Z, Zhao L F, et al. Detecting techniques of surface crack of pipeline based on laser ultrasonic[J]. Opto-Electronic Engineering, 2016, 43(3): 1–6.曹建树 , 曹振, 赵龙飞 , 等. 激光超声管道表面裂纹检测技术 [J]. 光电工程, 2016, 43(3): 1–6.

[5] Zhang P, Chen Z D, Li X X, et al. X-ray digital image of weld defect based on wavelet transform edge detection[J]. Pipeline Technique and Equipment, 2016(3): 41–43. 张盼, 陈志东, 李晓旭, 等. 基于小波变换的 X射线数字图像焊缝缺陷边缘检测[J].管道技术与设备, 2016(3): 41–43.

[6] Wang Z G,Luo QW, Shi Y B, et al. Analysis of eddy current coil coupling in ferromagnetic pipe and pipe’s parameter detection[J]. Chinese Journal of Scientific Instrument, 2014, 35(12): 2843–2851.王志刚 , 罗清旺 , 师奕兵 , 等. 铁磁性管道内涡流线圈耦合分析与管道参数检测[J].仪器仪表学报, 2014, 35(12): 2843–2851.

[7] Yang J X, Li C, Xia S, et al. Magnetostrictive guided wave flaw detection system for pipeline[J]. Instrument Technique and Sensor, 2017(6): 95–97, 167.杨金旭 , 李策, 夏胜, 等. 基于磁致伸缩导波的管道缺陷检测系统 [J].仪表技术与传感器, 2017(6): 95–97, 167.

[8] Su T C, Yang M D. Application of morphological segmentation to leaking defect detection in sewer pipelines[J]. Sensors, 2014, 14(5): 8686–8704.

[9] Vriesman D, Britto A S, Zimmer A, et al. Automatic visual in-spection of thermoelectric metal pipes[J]. Signal, Image and Video Processing, 2019, 13(5): 975–983.

[10] Yang Z Y, Lu S H,Wu T, et al. Detection of morphology defects in pipeline based on 3D active stereo omnidirectional vision sensor[J]. IET Image Processing, 2018, 12(4): 588–595.

[11] Wang Y, Zhang R. In-pipe surface circular structured light 3D vision inspection system[J]. Infrared and Laser Engineering, 2014, 43(3): 891–896. 王颖, 张瑞. 管道内表面圆结构光视觉三维测量系统 [J].红外与激光工程, 2014, 43(3): 891–896.

[12] Wu B, Shao Z Y, Zhang Y H. A new technology of building up defect measuring system for inner micro-pipe[J]. Journal of Op-toelectronics·Laser, 2014, 25(2): 293–298. 吴斌, 邵震宇, 张云昊 . 微细管道内壁缺陷测量系统构建和技术 [J].光电子·激光, 2014, 25(2): 293–298.

[13] Haertel M E M, da Costa Pinto T L F, Júnior A A G. Trinocular stereo system with object space oriented correlation for inner pipe inspection[J]. Measurement, 2015, 73: 162–170.

[14] Land E H, McCann J J. Lightness and retinex theory[J]. Journal of the Optical Society of America, 1971, 61(1): 1–11.

[15] Bradley D, Roth G. Adaptive thresholding using the integral image[J]. Journal of Graphics Tools, 2007, 12(2): 13–21.

[16] Wei W Y, Ren X K. Quadtree image retrieval based on image entropy[J]. Journal of Jiamusi University (Natural Science Edi-tion), 2005, 23(4): 511–514, 521.魏伟一, 任小康. 基于图像信息熵的四叉树检索算法 [J].佳木斯大学学报(自然科学版), 2005, 23(4): 511–514, 521.

[17] Ren H E, Liu M, Dong B Z. Edge detection algorithm of wood-flour based on modified morphological operator[J]. Com-puter Engineering and Applications, 2015, 51(5): 183–186.任洪娥 , 刘冕, 董本志. 基于改进形态学算子的木粉边缘检测算法 [J].计算机工程与应用, 2015, 51(5): 183–186.

[18] Hao L H, Wang M Q. Application of improved canny algorithm in defect edge detection of straight weld image[J]. Fire Control & Command Control, 2017, 42(7): 52–55.郝利华, 王明泉. 改进的 Canny算法在直焊缝图像缺陷边缘检测中的应用[J].火力与指挥控制, 2017, 42(7): 52–55.

[19] Lin H, Zhao C S, Shu N. Edge detection based on Canny oper-ator and evaluation[J]. Journal of Heilongjiang Institute of Technology, 2003, 17(2): 3–6, 16.林卉, 赵长胜, 舒宁. 基于 Canny算子的边缘检测及评价[J].黑龙江工程学院学报, 2003, 17(2): 3–6, 16.

[20] Chen H X. Study on the objective evaluation of the performance of edge detection operator based on the quality factor[J]. Auto-mation & Instrumentation, 2015(8): 8–10. 陈宏希 . 基于品质因数的边缘检测算子性能优劣客观评价研究 [J].自动化与仪器仪表, 2015(8): 8–10.

李平, 梁丹, 梁冬泰, 吴晓成, 陈兴. 自适应图像增强的管道机器人缺陷检测方法[J]. 光电工程, 2020, 47(1): 190304. Li Ping, Liang Dan, Liang Dongtai, Wu Xiaocheng, Chen Xing. Research on defect inspection method of pipeline robot based on adaptive image enhancement[J]. Opto-Electronic Engineering, 2020, 47(1): 190304.

本文已被 2 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!