532 nm 短/超短脉冲激光作用于蓝宝石的研究

王亭入; 季凌飞; 燕天阳; 林真源; 王文豪; 李健; 蒋毅坚

doi:doi:10.14128/j.cnki.al.20173702.251

应用激光, 2017, 37 (2): 251, 网络出版: 2017-06-08

532 nm 短/超短脉冲激光作用于蓝宝石的研究

Study on 532 nm Short/Ultrashort Pulse Laser Processing of Sapphire

论文大纲

王亭入 ^*季凌飞燕天阳林真源王文豪李健蒋毅坚

作者单位

北京工业大学激光工程研究院, 北京 100124

532 nm激光皮秒纳秒蓝宝石阈值 532 nm wavelength picosecond laser nanosecond laser sapphire threshold

摘要

分别采用波长为532 nm的短脉冲激光(脉宽6 ns)和超短脉冲激光(脉宽15～20 ps)对蓝宝石进行基本作用规律的研究, 探究了多/单脉冲烧蚀点直径与功率的关系, 分析脉冲数与材料阈值的关系, 确定材料阈值。并且对相关作用机理进行系统的对比分析。研究结果表明, 烧蚀点直径的平方与脉冲峰值功率的对数呈线性关系, 根据关系式计算得出光斑半径与实际测量值相符, 并且材料阈值随脉冲数的增加而降低。纳秒绿激光烧蚀蓝宝石材料主要是基于光热作用的机理, 而皮秒激光烧蚀蓝宝石材料在以“电子态”冷去除的同时, 还兼具一些非线性效应。

Abstract

Short pulse (6 ns) laser and vltrashort pluse (15～20 ps) laser with wavelength of 532 nm processing of sapphire were studied. The relation between power and diameter of ablated dot by multi/single-pulse machining was explored to make sure the ablation threshold. In addition, systemic comparison of relative mechanism was discussed. The results showed that the square of ablated dot diameter is proportional to the logarithm of peak pulse laser power. Calculation of the laser spot radius is matched with measured value according to the relation. Besides, the material ablation threshold decreases with the increasing of pulse numbers. The ablation process on sapphire by using 532 nm nanosecond laser is mainly due to the photothermal effect, while the ablation process by picosecond laser was considered to be cold removal based on "electronic state" as well as nonlinear effects.

参考文献

[1] 埃琳娜·R.多布文斯卡亚, 莱奥尼德·A.李托维诺夫, 瓦莱里安·皮斯奇克.蓝宝石: 材料、制造、应用［M］.张明福, 译.北京: 科学出版社, 2013: 1-79.

[2] SHAMIR A, ISHAAVA A A.Large volume ablation of Sapphire with ultra-short laser pulses［J］.Appl. Surf. Sci., 2013(270): 763-766.

[3] 陈超, 王进保, 肖乐银, 等.环形金刚石线锯切割蓝宝石试验研究［J］.超硬材料工程, 2012(4): 5-8.

[4] 李长青, 武万良, 左洪波, 等.长脉冲激光切割蓝宝石的断口分析［J］.人工晶体学报, 2010(4): 997-1001.

[5] 谢小柱, 黄显东, 陈蔚芳, 等.脉冲绿激光划切蓝宝石基片过程研究［J］.中国激光, 2013(12): 104-112.

[6] 白帆, 戴玉堂, 徐刚, 等.基于157 nm深紫外激光的蓝宝石基片微加工［J］.激光技术, 2010(5): 636-639.

[7] UTEZA O, BUSSIERE B, CANOVA F, et al.Laser-induced damage threshold of sapphire in nanosecond, picosecond and femtosecond regimes［J］.Appl. Sure. Sci., 2007, 254(4): 799-803.

[8] WANG X C, LIM G C, ZHENG H Y, et al.Femtosecond pulse laser ablation of sapphire in ambient air［J］.Appl. Surf. Sci., 2004,228(1-4):221-226.

[9] HAN J, LI C, ZHANG M, et al.An investigation of long pulsed laser induced damage in sapphire［J］.Optics & Laser Technology, 2009, 41(3): 339-344.

[10] LIU J M. Simple technique for measurements of pulsed Gaussian-beam spot sizes.［J］.Opt. Lett., 1982.

[11] YONG J, BECKER M F, WALSER R M.Laser-induced damage on single-crystal metal surfaces［J］.Journal of the Optical Society of America B, 1988.

[12] WANG X, SHEPHARD J D, DEAR F C, et al.Optimized nanosecond pulsed laser micromachining of Y-TZP ceramics［J］.J. AM. Ceram. Soc., 2008, 91(2): 391-397.

[13] 陈发良, 李东海.基于Fokker-Planck方程的电介质材料短脉冲激光破坏机制分析［J］.强激光与粒子束, 2011(2): 334-338.

[14] 季凌飞, 凌晨, 李秋瑞, 等.皮秒激光工程应用研究现状与发展分析［J］.机械工程学报, 2014(5): 115-126.

[15] 游牧.超短激光脉冲与透明介质相互作用［D］.西安: 中国科学院研究生院(西安光学精密机械研究所), 2005: 72-103.

王亭入, 季凌飞, 燕天阳, 林真源, 王文豪, 李健, 蒋毅坚. 532 nm 短/超短脉冲激光作用于蓝宝石的研究[J]. 应用激光, 2017, 37(2): 251. Wang Tingru, Ji Lingfei, Yan Tianyang, Lin Zhenyuan, Wang Wenhao, Li Jian, Jiang Yijian. Study on 532 nm Short/Ultrashort Pulse Laser Processing of Sapphire[J]. APPLIED LASER, 2017, 37(2): 251.

532 nm 短/超短脉冲激光作用于蓝宝石的研究

关于本站 Cookie 的使用提示

全站搜索

532 nm 短/超短脉冲激光作用于蓝宝石的研究

相关论文

相关资讯

关于本站 Cookie 的使用提示

全站搜索