测试设备位姿失调对自准直仪法测量圆分度误差的影响

为了提高圆分度仪器分度误差的测量精度, 介绍了用多面棱体自准直仪测量分度误差的原理和方法, 对影响测量结果的误差源进行了分析。根据测量原理建立了多面棱体和自准直仪坐标系, 利用坐标变换分别建立了多面棱体工作面与受检仪器轴线的平行差、自准直仪光轴与多面棱体工作面不垂直度误差、自准直仪电十字竖线与受检仪器轴线的平行差对分度误差影响的精确模型。在实验室内, 以单轴位置转台的定位精度为测试对象, 设计了以上三种位姿失调误差模型的验证实验, 实验结果与理论模型仿真结果具有很好的一致性, 三种位姿失调引入的误差实测值与理论值的最大偏差小于0.9″, 验证了位姿失调量引入测量误差模型的正确性, 该模型及仿真结果可以准确指导圆分度误差测试。

Abstract

In order to improve the measurement accuracy of dividing error of encoders, the principle and method to measure dividing error by using angular polygon and autocollimator were introduced, and the error sources were analyzed. According to the measurement principle, coordinate systems of angular polygon and autocollimator were established. Utilizing the method of coordinate transformation, precise mathematical models were deduced for indicating the relationships between dividing error and misalignment errors, such as parallelism error between the angular polygon working surface and the axis of the tested unit, perpendicularity error between autocollimator optical axis and the working surface of angular polygon, parallelism error between vertical wire of the autocollimator and the axis of the tested unit. In order to verify the error models of misadjustment, three experiments were performed in the laboratory, taking the positioning error of a single-axis position turntable as test object. The experimental and theoretical results have good consistency and the maximum deviation was less than 0.9″, which indicate that the error models of misadjustment are applicable to guide dividing error measurement.

参考文献

[1] 中华人民共和国国家质量监督检验检疫总局.JJG 283-2007正多面棱体检定规程［S］. 北京: 中国计量出版社, 2008.

General Administration of Quality Supervision, Inspection and Quarantine of the Peoples Republic of China. JJG 283-2007 verification regulation of angular polygon ［S］. Beijing: China Metrology Press, 2008. (in Chinese)

[2] 国家质量监督检验检疫总局.JJG 202-2007自准直仪检定规程［S］. 北京: 中国计量出版社, 2007.

General Administration of Quality Supervision, Inspection and Quarantine of the Peoples Republic of China. JJG 202-2007 verification regulation of autocollimators ［S］. Beijing: China Metrology Press, 2007. (in Chinese)

[3] 中华人民共和国国家质量监督检验检疫总局.JJF 1115-2004光电轴角编码器校准规范［S］. 北京: 中国计量出版社, 2005.

General Administration of Quality Supervision, Inspection and Quarantine of the Peoples Republic of China. JJF 1115-2004 calibration specification for photoelectric shaft encoders ［S］. Beijing: China Metrology Press, 2005. (in Chinese)

[4] WARNER M, KRABBENDAM V, SCHUMACHER G. Adaptive periodic error correction for Heidenhain tape encoders ［J］. SPIE, 2008, 7012: 70123N.

[5] DHAR V K, TICKOO A K, KAUL S K, et al.. Artificial neural network-based error compensation procedure for low-cost encoders ［J］. Measurement Science and Technology, 2010, 21(1): 015112.

[6] 冯英翘, 万秋华, 宋超, 等. 基于坐标旋转数字计算算法的小型光电编码器细分［J］. 光学学报, 2014, 34(2): 0205001.

FENG Y Q, WAN Q H, SONG CH, et al.. Interpolation of small photoelectric encoder based on coordinate rotation digital computer algorithm ［J］. Acta Optica Sinica, 2014, 34(2): 0205001. (in Chinese)

[7] 齐荔荔, 万秋华. 图像式光电编码器的测角技术及其硬件实现［J］. 光学学报, 2013, 33(4): 0412001.

QI L L, WAN Q H. Angle-measurement technology of an optical pattern rotary encoder and its hardware implementation ［J］. Acta Optica Sinica, 2013, 33(4): 0412001. (in Chinese)

[8] LOPEZ J, ARTES M. A new methodology for vibration error compensation of optical encoders ［J］. Sensors, 2012, 12(4): 4918-4933.

[9] 于海, 万秋华, 王树洁, 等. 小型绝对式光电轴角编码器动态误差分析［J］. 中国激光, 2013, 40(8): 0808004.

YU H, WAN Q H, WANG SH J, et al.. Dynamic errors analysis of small absolute photoelectric encoder ［J］. Chinese Journal of Lasers, 2013, 40(8): 0808004. (in Chinese)

[10] 冯英翘, 万秋华, 孙莹, 等. 近似三角波莫尔条纹光电信号的细分误差修正［J］. 光学学报, 2013, 33(8): 0812001.

FENG Y Q, WAN Q H, SUN Y, et al.. Interpolation error correction of moiré fringe photoelectric signals in the approximate form of triangle wave ［J］. Acta Optica Sinica, 2013, 33(8): 0812001. (in Chinese)

[11] 王显军. 光电轴角编码器细分信号误差及精度分析［J］. 光学精密工程, 2012, 20(2): 379-386.

WANG X J. Errors and precision analysis of subdivision signals for photoelectric angle encoders［J］. Opt. Precision Eng., 2012, 20(2): 379-386. (in Chinese)

[12] KAUL S K, TICKOO A K, KOUL R, et al.. Improving the accuracy of low-cost resolver-based encoders using harmonic analysis ［J］. Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2008, 586(2): 345-355.

[13] WATANABE T, FUJIMOTO H, NAKAYAMA K, et al.. Automatic high-precision calibration system for angle encoder ［J］. SPIE, 2001, 4401: 267-274.

[14] FILATOV Y V, AGAPOV M Y, BOURNACHEV M N. Laser goniometer systems for dynamic calibration of optical encoders ［J］. SPIE, 2003, 5144: 381-390.

[15] 孙树红, 梁立辉, 万秋华. 基于DSP的光电编码器自动检测系统［J］. 红外与激光工程, 2013, 42(9): 2536-2539.

SUN SH H, LIANG L H, WAN Q H. Automatic detection system for photoelectrical encoder based on DSP ［J］. Infrared and Laser Engineering, 2013, 42(9): 2536-2539. (in Chinese)

[16] 孙树红, 赵长海, 万秋华, 等. 小型光电编码器自动检测系统［J］. 中国光学, 2013, 6(4): 600-606.

SUN SH H, ZHAO CH H, WAN Q H, et al.. Automatic detection system for miniature photoelectrical encoder ［J］. Chinese Optics, 2013, 6(4): 600-606. (in Chinese)

[17] 张桂林, 姜涛, 李敏. 一种光电编码器转角精度检测方法的误差分析［J］. 中国激光, 2013, 40(8): 0808001.

ZHANG G L, JIANG T, LI M. Error analysis on measurement of photoelectrical encoder corner precision ［J］. Chinese Journal of Lasers, 2013, 40(8): 0808001. (in Chinese)

[18] 郭敬滨, 曹红艳, 王克新, 等. 转台分度误差的检定及补偿模型的建立［J］. 天津大学学报: 自然科学与工程技术版, 2014, 47(6): 524-529.

GUO J B, CAO H Y, WANG K X, et al.. Check of indexing error for turntable and establishment of its compensation model ［J］. Journal of Tianjin University: Science and Technology, 2014, 47(6): 524-529. (in Chinese)

[19] 卢荣胜, 李万红, 劳达宝, 等. 激光跟踪仪测角误差补偿［J］. 光学精密工程, 2014, 22(9): 2299-2305.

LU R SH, LI W H, LAO D B, et al.. Angular error compensation for laser tracker ［J］. Opt. Precision Eng., 2014, 22(9): 2299-2305. (in Chinese)

[20] 赵建科, 张周峰. 轴角编码器测量中偏心带来的误差分析［J］. 光子学报, 2007, 36(S1): 249-252.

ZHAO J K, ZHANG ZH F. Error analysis for measurement of encoder with shaft eccentricity ［J］. Acta Photonica Sinica, 2007, 36(S1): 249-252. (in Chinese)

[21] 田留德, 刘朝晖, 赵建科, 等. 利用坐标变换分析塔差对编码器测角精度测试的影响［J］. 光学学报, 2015, 35(5): 0512003.

TIAN L D, LIU CH H, ZHAO J K, et al.. Analysis the influence of pyramidal error on the encoder accuracy test by using coordinate transformation ［J］. Acta Optica Sinica, 2015, 35(5): 0512003. (in Chinese)

田留德, 赵建科, 王涛, 赵怀学, 段亚轩, 刘朝晖. 测试设备位姿失调对自准直仪法测量圆分度误差的影响[J]. 光学精密工程, 2017, 25(9): 2267. TIAN Liu-de, ZHAO Jian-ke, WANG Tao, ZHAO Huai-xue, DUAN Ya-xuan, LIU Zhao-hui. Influence of test equipment pose error on dividing error measurement based on autocollimator[J]. Optics and Precision Engineering, 2017, 25(9): 2267.

测试设备位姿失调对自准直仪法测量圆分度误差的影响

关于本站 Cookie 的使用提示

全站搜索

测试设备位姿失调对自准直仪法测量圆分度误差的影响

相关论文

相关资讯

关于本站 Cookie 的使用提示

全站搜索