延迟击穿半导体开关二极管最佳参数确定

分析了延迟击穿二极管(DBD,delayed breakdown diode)的物理机理.从该器件在负载上的输出脉冲幅度及上升时间两方面综合考虑,通过改变器件结构参数和物理参数(长度、面积、掺杂浓度、激励源等),模拟研究了不同激励源及不同负载情况下DBD特性的变化情况.结果表明: 上升时间对于面积和负载电阻均存在极小值,设计时面积和负载电阻应该选取该极值点对应的最佳值.n区长度存在最佳值,理论上应为器件加载在所需临界击穿电压值而且刚好处于穿通状态时的长度值;p⁺区和n⁺区的长度没有太大的影响,但应稍大于各自的穿通长度,浓度则尽量高;n区掺杂浓度越低越好,对激励源要求电流稍高于临界条件即可.

Abstract

The physical mechanism of delayed breakdown diode(DBD) was analyzed. Considering both the amplitude and the rise time of the output pulse across the load, the characteristics of DBD with different structure parameters and physical parameters (length, area, doping and the stimulating source) were simulated. The simulation results show that there exists a minimum value for rise time with respect to both the area of the DBD and the load resistance. The minimum value should be adopted in design. Theoretically the optimum length of n region should be the maximum punching through length. The lengths of p⁺ region and n⁺ region have little influence on the DBD performance, which should be greater than their punching through lengths. And their doping density, the higher the better. As regard to the n region doping density, the lower the better. The current of the stimulating source should be a little bigger than that of the critical condition.

参考文献

[1] Grekhov I V, Kardo-Sysoev A F. Subnanosecond current drops in delayed breakdown of silicon p-n junctions[J]. Sov Tech Phys Lett,1979, 5(8):395.

[2] Kardo-Sysoev A F, Efanov V M, Chashnikov I G. Fast power switches from picosecond to nanosecond time scale and their application to pulsed power[A]. Pulsed Power Conference, 1995., Digest of Technical Papers. , Tenth IEEE International[C]. 1995, 1:342.

[3] Rukin S N, Alichkin E A, Alichkin, et al. SOS/DBD-based solid state switching for ultra-high-power Short pulse generation[A]. Power Modulator Symposium, 2002 and 2002 High-Voltage Workshop. , Conference Record of the Twenty-Fifth International[C] . 2002, 30:178-182.

[4] Frost C A. Focia R J. Stockebrand T C, et al. Multi-kilovolt solid-state picosecond switch studies[A]. Pulsed Power Plasma Science, 2001, PPPS-2001, Digest of Technical Papers[C]. 2001, 1:17-22.

[5] 苏建仓, 丁永忠, 宋志敏, 等.半导体断路开关实验研究[J]. 强激光与粒子束,2002, 14(6):949.
Su J C, Ding Y Z, Song Z M, et al. Experimental study on the characteristics of semiconductor opening switch [J]. High Power Laser and Particle Beams, 2002, 14(6):949.

[6] 张适昌, 严萍, 王珏. 半导体断路开关及其应用[J]. 高电压技术, 2002, 28(120):23.
Zhang S C, Yan P, Wang J. Study of semiconductor switch and its application[J]. High Voltage Engineering, 2002, 28(120):23.

[7] Focia R J, Schamiloglu Edl, , et al. Silicon diode in avalanche pulse-sharpening applications[J]. IEEE Trans on Plasma Science, 1997, 25(2):138.

余稳, 谭述奇, 张飞, 张义门, 孙晓玮. 延迟击穿半导体开关二极管最佳参数确定[J]. 强激光与粒子束, 2005, 17(7): 1043. YU Wen, TAN Shu-qi, ZHANG Fei, ZHANG Yi-men, SUN Xiao-wei. Best parameters for the delayed breakdown diode[J]. High Power Laser and Particle Beams, 2005, 17(7): 1043.

延迟击穿半导体开关二极管最佳参数确定

关于本站 Cookie 的使用提示

全站搜索

延迟击穿半导体开关二极管最佳参数确定

相关论文

相关资讯

关于本站 Cookie 的使用提示

全站搜索