光学学报, 2011, 31 (4): 0422001, 网络出版: 2011-03-30   

用正弦光栅的朗奇法检验大口径非球面面形

Large-Aperture Aspheric Surfaces Testing by Using Sinusoidal Grating Based on Ronchi Method
作者单位
1 四川大学光电科学技术系, 四川 成都 610064
2 中国科学院光电技术研究所, 四川 成都 610209
摘要
基于朗奇(Ronchi)检验法和同步相位探测技术,在点光源离轴情况下提出一种检验非球面反射镜的方法。该方法利用透射液晶显示器(LCD)显示垂直和水平两个方向的正弦光栅,由摄像机记录经被测镜面反射产生的光栅变形条纹图,通过四步相移法获得条纹图的相位分布。由变形条纹和光栅的同名相位点确定被测镜面每一点的横向像差,对应理想镜面的横向像差由几何关系算出,通过两镜面对应点的横向像差之差获得待测点面形偏差的梯度信息,对其积分恢复面形偏差,最后重建被测面形。检测中光栅由计算机产生,可实现精确的相移,使垂直和水平光栅严格达到90°。采用预设标记点来引导相位展开,有效地解决了变形条纹和光栅的相位对应问题。模拟和实验初步验证了这一方法的可行性。
Abstract
A method based on Ronchi test and synchronous phase detection technology is presented to measure the aspheric mirror, where the point source is located beside the axis of the surface. A liquid crystal display screen displays the vertical and horizontal sinusoidal gratings and a camera captures the deformed fringe patterns generated by the reflection of the mirror. By four-step phase-shifting technique, the phase distributions are obtained. According to points with the same phase on the deformed fringes and grating, the transverse aberration of all tested points can be calculated, while that of the relevant ideal mirror can be worked out by geometry algorithms. Then the residual transverse aberration can be taken and thus the gradient of shape deviation can be determined. Tested mirror can be reconstructed after restoring shape deviations by integral processing. In experiment, the computer-generated fringe will bring a no-error phase shift and control the angle of two gratings to be 90°. A marked point is used to guide the phase unwrapping procedure. Computer simulations and preliminary experiment validate the feasibility of this method.
参考文献

[1] 潘君骅. 光学非球面的设计、加工与检验[M]. 北京:科学出版社, 2004. 10~89

    Pan Junhua. The Design, Manufacture and Test of The Aspherical Optical Surfaces[M]. Beijing: Science press, 2004. 10~89

[2] 潘君骅. 谈谈光学检测的指导思想[J]. 光学与光电技术, 2004, 2(6): 1~3

    Pan Junhua. Talk about the guidance thought of the optical testing[J]. Optical and Opto-Electronic Technology, 2004, 2(6): 1~3

[3] 唐燕, 苏显渝, 刘元坤 等. 基于条纹反射的非球面镜三维面形测量[J]. 光学学报, 2009, 29(4): 965~969

    Tang Yan, Su Xianyu, Liu Yuankun et al.. Three-dimensional shape measurement of aspheric mirror based on fringe reflection[J]. Acta Optica Sinica, 2009, 29(4): 965~969

[4] 雷柏平, 伍凡, 周晨波. 龙基光栅在大口径非球面定量测量中的应用[J]. 光学学报, 2009, 29(9): 2441~2446

    Lei Baiping, Wu Fan, Zhou Chenbo. Application of ronchi grating to the quantitative measurement of large-aperture aspheric surfaces[J]. Acta Optica Sinica, 2009, 29(9): 2441~2446

[5] D. Malacara. Optical Shop Testing[M]. New York: John Wiley & Sons, Inc., 2007. 317~360

[6] . Ronchi. Due nuovi metodi perlostudio delle superficie edeisistemiottici[J]. Ann. Sc. Norm. Super Pisa, 1923, 26(1): 69-71.

[7] . Malacara. Geometrical Ronchi test of aspherical mirrors[J]. Appl. Opt., 1965, 4(11): 1371-1374.

[8] . Yatagai. Fringe scanning Ronchi test for aspherical surfaces[J]. Appl. Opt., 1984, 23(20): 3676-3679.

[9] . Omura, T. Yatagai. Phase measuring Ronchi test[J]. Appl. Opt., 1988, 27(3): 523-528.

[10] . Lee, Seung-Woo Kim. Precision profile measurement of aspheric surfaces by improved Ronchi test[J]. Opt. Eng., 1998, 38(6): 1041-1047.

[11] . Arasa, S. Royo, N. Tomas. Simple method for improving the sampling in profile measurements by use of the Ronchi test[J]. Appl. Opt., 2000, 39(25): 4529-4534.

[12] 伍凡, 陈燕明. 用刀口郎奇光栅法检验大型光学镜面面形[J]. 光电工程, 1988, 15(1): 27~33

    Wu Fan, Chen Yanming. The surface shape of large optical mirror testing by using knife-edge Ronchi[J]. Opt. Engineering, 1988, 15(1): 27~33

[13] Baiping Lei, Fan Wu, Chenbo Zhou. Quantitative measurement of 630 mm F/1.34 parabolic surfaces with Ronchi grating test method[J]. Chin. Opt. Lett., 2009, 7(7): 590~592

[14] . Cornejo, D. Malacara. Ronchi test of aspherical surfaces, analysis, and accuracy[J]. Appl. Opt., 1970, 9(8): 1897-1901.

[15] . 基于傅里叶条纹分析的摄像机标定[J]. 四川大学学报(工程科学版), 2007, 39(6): 149-153.

    . A new camera calibration technique using FTP method[J]. J. Sichuan University (Engineering Science Edition), 2007, 39(6): 149-153.

[16] 荆海龙, 苏显渝, 刘元坤 等. 基于条纹反射的镜面测量及三维重建算法分析[J]. 光电工程, 2008, 35(10): 37~42

    Jing Hailong, Su Xianyu, Liu Yuankun et al.. Specular surface measurement based on fringe reflection and analysis of 3D shape reconstruction technique[J]. Opto-Electronic Engineering, 2008, 35(10): 37~42

郭春凤, 苏显渝, 窦蕴甫, 陈文静, 雷柏平, 伍凡. 用正弦光栅的朗奇法检验大口径非球面面形[J]. 光学学报, 2011, 31(4): 0422001. Guo Chunfeng, Su Xianyu, Dou Yunfu, Chen Wenjing, Lei Baiping, Wu Fan. Large-Aperture Aspheric Surfaces Testing by Using Sinusoidal Grating Based on Ronchi Method[J]. Acta Optica Sinica, 2011, 31(4): 0422001.

本文已被 3 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!