1 重庆邮电大学工业物联网与网络化教育部重点实验室,重庆 400065
2 重庆邮电大学通信与信息工程学院,重庆 400065
针对脉搏波信号采集过程中存在噪声的问题,提出了基于改进互补集成经验模态分解的脉搏波去噪算法。利用光纤布拉格光栅传感器获取脉搏波信号,首先在互补集成经验模态分解算法中加入高斯白噪声,然后利用粒子群算法优化高斯白噪声幅值,以此来消除互补集成经验模态算法分解产生的模态混叠现象,并联合小波阈值函数对其处理后的脉搏波信号进行重构。实验结果表明,所提算法能够有效降低脉搏波信号中的噪声干扰,在信噪比、均方误差两个指标上均优于对比算法,为提取脉搏波的时域特征奠定了基础。
光纤布拉格光栅 脉搏波 信号去噪 互补集成经验模态分解 粒子群优化算法 小波阈值
1 北京信息科技大学 光电测试技术及仪器教育部重点实验室,北京 100192
2 北京信息科技大学 光纤传感与系统北京实验室,北京 100016
3 北京空间机电研究所, 北京 100089
4 广州南沙光子感知技术研究院,广东 广州 511462
为了研制一种微小型、三轴测量的高灵敏度振动传感器,提出一种分立元件交错组合的超紧凑光纤光栅三轴振动传感器设计方法。采用分立元件组合设计方法降低了设计加工难度,与一体化设计对比,分立元件组合结构的零件结构简单、易于加工、结构设计也更为灵活,缩短了传感器结构的优化迭代周期。通过理论模型分析和有限元仿真,优化传感器结构参数,最终封装完成的尺寸为15 mm×15 mm×15 mm,质量约为24.26 g。最后进行实验测试和传感器性能分析。实验结果表明:该传感器的工作频段为0~1 200 Hz,在X、Y、Z轴方向的固有频率分别为1 850 Hz、1 770 Hz和1 860 Hz,三个轴向的灵敏度分别达到77.37 pm/g、80.73 pm/g和75.04 pm/g,横向抗干扰小于5%。该传感器满足航天振动测量轻量化、工作范围和灵敏度的应用需求,在遥感卫星微振动测量等领域具有重要应用前景。
光纤布拉格光栅 三轴振动传感器 微型化 高灵敏度 fiber Bragg grating triaxial vibration sensor microminiaturization high sensitivity 红外与激光工程
2024, 53(2): 20230518
1 三峡大学湖北省弱磁探测工程技术研究中心,湖北 宜昌 443002
2 三峡大学理学院,湖北 宜昌 443002
提出了一种基于超弱光纤光栅阵列的长距离传感系统。基于超弱光纤光栅的离散分布和高信噪比特点,采用分段采集的方法降低系统对数据缓存和计算能力的要求,利用ZYNQ(ZYNQ-7035 All Programmable SoC)嵌入式底层硬件实现对选定空间上10 km传感段的解调。采用OptiSystem软件仿真分析系统的功率预算,精准设计入纤脉冲光功率以及拉曼光纤放大器的配置,结合电路的动态分段增益,实现长距离传感系统中的功率均衡,并搭建实验系统予以验证。结果表明:系统工作距离可以达到50 km,传感信号的强度波动小于2.2 dB,空间分辨率为1.5 m,解调速度为0.3 Hz,远端的解调精度稳定在6 pm以内,温度测量精度为±0.15 ℃,应变测量精度为±5.5 με。系统整体性能优于传统的分布式布里渊传感系统,且具有良好的可扩展性,在长距离光纤温度、应变感测上具有明显的技术优势。
光纤布拉格光栅 长距离传感 光纤传感系统 拉曼光纤放大器 激光与光电子学进展
2024, 61(5): 0506005
1 重庆理工大学智能光纤感知技术重庆市高校工程研究中心重庆市光纤传感与光电检测重点实验室,重庆 400054
2 眉山三苏祠博物馆,四川 眉山 620010
3 重庆自然博物馆,重庆 400711
为了实现相对湿度高灵敏、快速、准确的检测,本文提出了一种基于壳聚糖/聚乙烯醇/纳米碳粉复合物涂敷的光纤布拉格光栅湿度传感器。建立了传感器检测相对湿度的理论模型。实验研究了湿度敏感(简称湿敏)膜成分与厚度、温度及光辐射对传感器性能的影响。研究表明,当壳聚糖与聚乙烯醇中纳米碳粉掺杂的质量分数为10%、湿敏膜厚度为185 μm时,相对湿度在20%RH~90%RH(相对湿度单位)范围内传感器灵敏度达到57.7 pm/(%RH),响应时间为420 s,恢复时间为540 s。将传感器封装在黑色聚四氟乙烯毛细管内,且通过引入温度补偿光纤布拉格光栅(FBG-T)的方法对温度进行解耦后,在温度为5~65 ℃、光辐射波长为220~1200 nm、光辐射强度为50 mW/cm2时,传感器测量结果可免疫温度和光辐射的影响,测量结果准确性高、重复性好,且最大相对误差小于5.8%。
光纤布拉格光栅 湿度传感器 灵敏度 响应时间 准确度
Author Affiliations
Abstract
1 College of Optical and Electronic Technology, China Jiliang University, Hangzhou 310018, China
2 College of Materials and Chemistry, China Jiliang University, Hangzhou 310018, China
The pandemic of respiratory diseases enlightened people that monitoring respiration has promising prospects in averting many fatalities by tracking the development of diseases. However, the response speed of current optical fiber sensors is still insufficient to meet the requirements of high-frequency respiratory detection during respiratory failure. Here, a scheme for a fast and stable tachypnea monitor is proposed utilizing a water-soluble C60-Lys ion compound as functional material for the tracking of humidity change in the progression of breath. The polarization of C60-Lys can be tuned by the ambient relative humidity change, and an apparent refractive index alteration can be detected due to the small size effect. In our experiments, C60-Lys is conformally and uniformly deposited on the surface of a tilted fiber Bragg grating (TFBG) to fabricate an ultra-fast-response, high-sensitivity, and long-term stable optical fiber humidity sensor. A relative humidity (RH) detecting sensitivity of 0.080 dB/% RH and the equilibrium response time and recovery time of 1.85 s and 1.58 s are observed, respectively. Also, a linear relation is detected between the resonance intensity of the TFBG and the environment RH. In a practical breath monitoring experiment, the instantaneous response time and recovery time are measured as 40 ms and 41 ms, respectively, during a 1.5 Hz fast breath process. Furthermore, an excellent time stability and high repeatability are exhibited in experiments conducted over a range of 7 days.
humidity sensor fullerene derivative optical fiber sensing tilted fiber Bragg grating nanomaterials Chinese Optics Letters
2024, 22(2): 021201
1 中山大学电子与信息工程学院,广东 广州 510006
2 华东师范大学精密光谱科学与技术国家重点实验室,上海 200241
目前光声成像中用于探测超声波的主流器件是基于压电材料的超声换能器,考虑到这类换能器的探测性能随器件尺寸的减小而大幅下降,科研者们近年来开始逐渐关注于小型化光学超声传感器的研究与开发。相较于传统的压电超声换能器,这些小型化的光学超声传感器通常具备较宽的探测带宽和与尺寸几乎无关的高灵敏度,在推动更深和更高分辨率的光声成像方面展现出了巨大的潜力。本文首先对光学超声传感器的发展历程进行了简要回顾,然后比较了3种重要的小型化光学超声传感器以及并行寻址的方法,其次介绍了这些传感器在光声活体成像方面的应用进展,最后展望了光学超声传感器的未来前景。
光声成像 光学超声传感器 片上器件 法布里-珀罗干涉仪 光纤布拉格光栅 微环谐振器 激光与光电子学进展
2024, 61(2): 0211032
Author Affiliations
Abstract
1 Department of Applied Physics, College of Mathematics and Physics, Chengdu University of Technology, Chengdu 610059, China
2 School of Electronics and Information, Northwestern Polytechnical University, Xi’an 710072, China
3 Chengdu Development Center of Science and Technology of CAEP, Chengdu 610299, China
Aiming for suppressing side-mode and spectrum broadening, a slit beam-shaping method and super-Gaussian apodization processing for femtosecond laser point-by-point (PbP) inscription technology of fiber Bragg gratings (FBGs) are reported here. High-quality FBGs, featuring narrow bandwidth of less than 0.3 nm, high reflectivity above 85%, low insertion loss (0.21 dB), and low cladding loss (0.82 dB), were obtained successfully. By a semi-automatic PbP inscription process, an array consisting of six FBGs, exhibiting almost no side-mode peaks with high suppression ability and narrow bandwidth, was fabricated along three independently developed single-mode fibers with an interval of 20 mm.
femtosecond laser processing fiber Bragg grating slit beam shaping Chinese Optics Letters
2024, 22(1): 010501