基于布喇格光纤光栅的电沉积应力演变测试

饶春芳; 刘程; 叶志清

doi:doi:10.3788/gzxb20154402.0206002

光子学报, 2015, 44 (2): 0206002, 网络出版: 2015-02-15

基于布喇格光纤光栅的电沉积应力演变测试

Stress Evolution Sensing Technique for Electrodeposition Based on Fiber Bragg Grating

论文大纲

饶春芳 ^*刘程叶志清

作者单位

江西师范大学物理与通信电子学院, 江西省光电子与通信重点实验室, 南昌 330022

摘要

提出了一种测试电沉积应力演变的方法.其机理为当带金属包层的布喇格光纤光栅为阴极进行电沉积时, 在沉积应力作用下, 布喇格光纤光栅的中心波长将发生漂移, 以此可推知沉积应力的大小.测试中首先利用光纤光栅解调仪记录电沉积应力作用下的布喇格光纤光栅中心波长的偏移量, 并将整个沉积时间分成小的时间段;然后依据沉积速度和标定的不同沉积厚度下的布喇格光纤光栅应力灵敏度, 计算出每时间段的应力值;最后将各时间段应力累加以获得累积应力随时间的演变.以电镀镍为例, 使用涂覆有化学镀镍磷金属包层的布喇格光纤光栅传感器, 进行电沉积应力测试, 测试表明：当测试镍镀层厚度小于50 μm时, 传感器灵敏度大于7pm/MPa, 准确度大于0.14 MPa;在6 000 s的电镀时间内, 累积压应力为173.049 9 MPa.

Abstract

A novel method for measuring electrodeposition stress was presented.Its mechanism is that the center wavelength of metal coated Fiber Bragg Grating sensor shifts under the action of the electrodeposition stress when the FBG is used as cathode in electrodeposition;based on the shift,the stress can be calculated.In the measurement,the center wavelength shifts of the FBG during deposition are recorded by FBG interrogator and these records are divided into many time segments with equal interval.Based on average depositing velocity and the relationship of FBG′s stress sensitivities with deposition thickness, the stresses producing in every time segment are calculated individually.Stress evolution is obtained by adding up these segmental stresses.The process is stress evolution during electroplating nickel was tested by using electroless Ni-P coated FBG sensor.The result shown that the FBG′s sensitivity is higher than 7pm/MPa under the condition that the nickle thickness is less than 50μm,and the degree of accuracy is more than 0.14 MPa.After deposition for 6 000 s,the accumulative pressure stress is 173.049 9 MPa.

参考文献

[1] WANG Z K,FENG E X,ZHANG Y,et al.Optimum electrodeposition conditions of FeCoZr films with in-plane uniaxial anisotropy for high frequency application［J］.Materials Chemistry and Physics,2012,137(2): 499-502.

[2] CHEND Z,JANG D,GUAN K M,et al.Nanometallic Glasses: size reduction brings ductility,surface state drives its extent［J］.Nano Letters,2013,13(9): 4462-4468.

[3] NGUYEN V C,LEE C Y,CHEN F J,et al.Study on the internal stress of nickel coating electrodeposited in an electrolyte mixed with supercritical carbon dioxide［J］.Surface and Coatings Technology,2012,206(14): 3201-3207.

[4] 成果简报：高应力镍电镀工艺的研究成果［J］.表面工程资讯,2012: 15.

Achievement bulletin: Study achievement of electroplating nickel technique with high stress［J］.Information of Surface Engineering,2012: 15.

[5] HAISS W,NICHOLS R J,SASS J K.In situ monitoring of intrinsic stress changes during copper electrodeposition on Au(111)［J］.Surface Science,1997,388(1–3): 141-149.

[6] SETHURAMAN V A,CHON M J,SHIMSHAK M,et al.In situ measurements of stress evolution in silicon thin films during electrochemical lithiation and delithiation［J］.Journal of Power Sources,2010,195(15): 5062-5066.

[7] LEE C C, TIEN C L, SHEN W S, et al.An apparatus for the measurement of internal stress and thermal expansion coefficient of metal oxide films［J］.Review of Scientific Instruments,2001,72(4): 2128-2133.

[8] WANG Sha-sha,CHEN Jing,LI Da-chao,et al.Evaluating interface effect on stresses in thin films by alocal curvature metrology with high accuracy and resolution［C］.Proceedings of the 1st IEEE InternationalConference on Nano/Micro Engineered and Molecular Systems,2006: 1513-1516.

[9] HE Q, LUO Z X, CHENX Y.Comparison of residual stress measurement in thin films using surface micromachining method［J］.Thin Solid Films,2008,516(16): 5318-5323.

[10] SEUNG H Y, VON P F J, KIM E S.Electroless nickel films: properties and fabricated cavity structure［J］.Journal of Microelectromechanical Systems,2002,11(4): 293-301.

[11] 王生钊, 张丹.薄膜应力测量方法进展［J］.南阳理工学院学报,2012,4(4): 67-71.

WANG Sheng-zhao,ZHANG Dan.Progress on measurement methods of stress in thin film［J］.Jorunal of Nanyang Institute of Technology,2012,4(4): 67-71.

[12] 李智,杨明红,代吉祥,等.Pt/WO3光纤光栅氢气传感器改性研究［J］.光子学报,2013,42(9): 1046-1051.

LI Zhi,YANG Ming-hong,DAI Ji-xiang,et al.Improvment research of fiber-optic hydrogen gas sensor using Pt catalyzed tungsten trioxide［J］.Acta Photonica Sinica,2013,42(9): 1046-1051.

[13] 余有龙,薛航,王彦晓,等.基于光纤光栅的物体表面附近温度场测量［J］.光子学报,2014,43(5): 0506001.

YU You-long,XUE Hang,WANG Yan-xiao,et al.Temperature distributed sensing technique for the local-area of the surface based on fiber Bragg gratings［J］.Acta Photonica Sinica,2014,43(5): 0506001.

[14] RAO C, ZHANG H, FENG Y, et al.Effect of metalizing nickel on the spectrum of fiber Bragg grating［J］.Optical Engineering,2013,52(5): 054404-054404.

[15] 饶春芳, 张华, 冯艳, 等.化学镀Ni-P 光纤布拉格光栅的均匀轴向拉力响应［J］.光学精密工程,2012,20(6): 1194-1200.

RAO Chun-fang,ZHANG Hua,FENG Yan,et al.Uniform axial tension effect on electroless plating Ni-P coated fiber Bragg grating［J］.Optics and Precision Engineering,2012,20(6): 1194-1200.

[16] DINI J W.Electrodeposition: the materials science of coatings and substrates［M］.New Jersey: Noyes Publications,1993,279-301.

[17] CHASON E,SHIN J W,CHEN C H, et al.Growth of patterned island arrays to identify origins of thin film stress［J］.Journal of Applied Physics,2014,115(12): 123519.

[18] 美国微光光学(Micron Optics)公司光纤光栅解调仪产品资料［EB/OL］.http: //www.micronoptics.com.cn/sensing_2.htm.

Product datum for optical fiber Sensing Interrogators of Micron Optics Inc.［EB/OL］.http: //www.micronoptics.com.cn/sensing_2.htm.

[19] FILAS R W.Metallization of silica optical fibers ［C］.MRS Proceedings,1998,531: 263-272.

饶春芳, 刘程, 叶志清. 基于布喇格光纤光栅的电沉积应力演变测试[J]. 光子学报, 2015, 44(2): 0206002. RAO Chun-fang, LIU Chen, YE Zhi-qing. Stress Evolution Sensing Technique for Electrodeposition Based on Fiber Bragg Grating[J]. ACTA PHOTONICA SINICA, 2015, 44(2): 0206002.

基于布喇格光纤光栅的电沉积应力演变测试

关于本站 Cookie 的使用提示

全站搜索

基于布喇格光纤光栅的电沉积应力演变测试

相关论文

相关资讯

关于本站 Cookie 的使用提示

全站搜索