The influence of the fourth-order dispersion coefficient on the behavior of parametric gain and saturation power of a one-pump fiber optical parametric amplifier over a signal wavelength span in the presence of fiber random dispersion fluctuations was investigated. The output signal power for the parametric gain calculation was obtained by numerically solving the three-coupled amplitude equations. Based on the calculations of the parametric gain over a variation of the signal wavelength, it is found that the saturation power behavior is dependent on the behavior of parametric gain. The manipulations of signal wavelength and the fourth-order dispersion coefficient changed the phase-matching condition, thereby affecting the resulting parametric gain and saturation power.

A polarization-diversity loop with a silicon waveguide with a lateral p-i-n diode as a nonlinear medium is used to realize polarization insensitive four-wave mixing. Wavelength conversion of seven dual-polarization 16-quadrature amplitude modulation (QAM) signals at 16 GBd is demonstrated with an optical signal-to-noise ratio penalty below 0.7 dB. High-quality converted signals are generated thanks to the low polarization dependence (≤0.5 dB) and the high conversion efficiency (CE) achievable. The strong Kerr nonlinearity in silicon and the decrease of detrimental free-carrier absorption due to the reverse-biased p-i-n diode are key in ensuring the high CE levels.

We investigate frequency-comb generation in normal dispersion silicon microresonators from the near-infrared to mid-infrared wavelength range in the presence of multiphoton absorption and free-carrier effects. It is found that parametric oscillation is inhibited in the telecom wavelength range resulting from strong two-photon absorption. On the contrary, beyond the wavelength of 2200 nm, where three- and four-photon absorption are less detrimental, a comb can be generated with moderate pump power, or free-carriers are swept out by a positive-intrinsic-negative structure. In the temporal domain, the generated combs correspond to flat-top pulses, and the pulse duration can be easily controlled by varying the laser detuning. The reported comb generation process shows a high conversion efficiency compared with anomalous dispersion regime, which can guide and promote comb formation in materials with normal dispersion. As the comb spectra cover the mid-infrared wavelength range, they can find applications in comb-based radiofrequency photonic filters and mid-infrared spectroscopy.

We experimentally demonstrate high-efficiency and broadband four-wave mixing in a silicon-graphene strip waveguide. A four-wave mixing conversion efficiency of 38.7 dB and a 3-dB conversion bandwidth of 35 nm are achieved in the silicon-graphene strip waveguide with an optimized light-graphene interaction length of 60 μm. The interaction length is controlled by a windowed area of silica layer on the silicon waveguide. Numerical simulations and experimental studies are carried out and show a nonlinear parameter γGOS as large as 104 W 1 ·m 1.

Microcomb generation with simultaneous χ(2) and χ(3) nonlinearities brings new possibilities for ultrabroadband and potentially self-referenced integrated comb sources. However, the evolution of the intracavity field involving multiple nonlinear processes shows complex dynamics that are still poorly understood. Here, we report on strong soliton regulation induced by fundamental–second-harmonic (FD-SH) mode coupling. The formation of solitons from chaos is extensively investigated based on coupled Lugiato–Lefever equations. The soliton generation shows more deterministic behaviors in the presence of FD-SH mode interaction, which is in sharp contrast with the usual cases where the soliton number and relative locations are stochastic. Deterministic single soliton transition, soliton binding, and prohibition are observed, depending on the phase-matching condition and coupling coefficient between the fundamental and second-harmonic waves. Our finding provides important new insights into the soliton dynamics in microcavities with simultaneous χ(2) and χ(3) nonlinearities and can be immediate guidance for broadband soliton comb generation with such platforms.

Searching for an ultrahigh-repetition-rate pulse on the order of hundreds of gigahertz (GHz) is still a challenging task in the ultrafast laser community. Recently, high-quality silicon/silica-based resonators were exploited to generate a high-repetition-rate pulse based on the filter-driven four-wave mixing effect in fiber lasers. However, despite their great performance, the silicon/silica-based resonators still have some drawbacks, such as single waveband operation and low coupling efficiency between the fiber and resonators. To overcome these drawbacks, herein we proposed an all-fiber broadband resonator fabricated by depositing the graphene onto a microfiber knot. As a proof-of-concept experiment, the graphene-deposited broadband microfiber knot resonator (MKR) was applied to Er- and Yb-doped fiber lasers operating at two different wavebands, respectively, to efficiently generate hundreds-of-GHz-repetition-rate pulses. Such a graphene-deposited broadband MKR could open some new applications in ultrafast laser technology, broadband optical frequency comb generation, and other related fields of photonics.

In this work, we report the modeling and the experimental demonstration of intermodal spontaneous as well as stimulated four-wave mixing (FWM) in silicon waveguides. In intermodal FWM, the phase-matching condition is achieved by exploiting the different dispersion profiles of the optical modes in a multimode waveguide. Since both the energy and the wave vectors have to be conserved in the FWM process, this leads to a wide tunability of the generated photon wavelength, allowing us to achieve a large spectral conversion. We measured several waveguides that differ by their widths and demonstrate large signal generation spanning from the pump wavelength (1550 nm) down to 1202 nm. A suited setup evidences that the different waves propagated indeed on different order modes, which supports the modeling. Despite observing a reduced efficiency with respect to intramodal FWM due to the decreased modal overlap, we were able to show a maximum spectral distance between the signal and idler of 979.6 nm with a 1550 nm pump. Our measurements suggest the intermodal FWM is a viable means for large wavelength conversion and heralded photon sources.

We experimentally demonstrate a heralded single photon source at 1290 nm by exploiting the spontaneous four wave mixing in a taper-drawn micro/nano-fiber (MNF). Because the frequency detuning between the pump and heralded single photons is ～58 THz, the contamination by Raman scattering is significantly reduced at room temperature. Since the MNF is naturally connected to standard single mode fibers via fiber tapers, the source would be compatible with the existing fiber networks. When the emission rate of heralded signal photons is about 4.6 kHz, the measured second-order intensity correlation function g(2)(0) is 0.017±0.002, which is suppressed by a factor of more than 55, relative to the classical limit.

We report on the enhancement of phase conjugation degenerate four-wave mixing (DFWM) in hot atomic Rb vapor by using a Bessel beam as the probe beam. The Bessel beam was generated using cross-phase modulation based on the thermal nonlinear optical effect. Our results demonstrated that the DFWM signal generated by the Bessel beam is about twice as large as that generated by the Gaussian beam, which can be attributed to the extended depth and tight focusing features of the Bessel beam. We also found that a DFWM signal with reasonable intensity can be detected even when the Bessel beam encounters an obstruction on its way, thanks to the self-healing property of the Bessel beam. This work not only indicates that DFWM using a Bessel beam would be of great potential in the fields of high-fidelity communication, adaptive optics, and so on, but also suggests that a Bessel beam would be of significance to enhance the nonlinear process, especially in thick and scattering media.

Dual combs are an emerging tool to obtain unprecedented resolution, high sensitivity, ultrahigh accuracy, broad bandwidth, and ultrafast data updating rate in the fields of molecular spectroscopy, optical metrology, as well as optical frequency synthesis. The recent progress in chip-based microcombs has promoted the on-chip dual-comb measuring systems to a new phase attributed to the large frequency spacing and broad spectrum. In this paper, we demonstrate proof-of-concept dual-comb generation with orthogonal polarization in a single microresonator through pumping both the transverse-electric (TE) and transverse-magnetic (TM) modes simultaneously. The two orthogonal polarized pumps are self-oscillating in a fiber ring cavity. The generated dual comb exhibits excellent stability due to the intrinsic feedback mechanism of the self-locked scheme. The repetition rate of the two orthogonal combs is slightly different because of the mode spacing difference between the TE and TM modes. Such orthogonal polarized dual-combs could be a new comb source for out-of-lab applications in the fields of integrated spectroscopy, ranging measurement, optical frequency synthesis, and microwave comb generation.